Bosch Dishwasher DF481701 Parts

This insulating plate is a molded heat shield that protects surrounding cabinet and components from high temperatures. It helps maintain safe appliance operation and prevents heat transfer to adjacent parts. What it does

• Shields adjacent cabinet surfaces and wiring from direct heat
• Helps maintain internal temperature balance for consistent operation
• Reduces risk of heat-related damage or discoloration to neighboring components
• Common symptom: visible heat damage, burnt odor, or degraded insulation around the appliance

• One insulating plate

• Inspect surrounding fasteners and mounting clips; replace any that are damaged
• Disconnect power and allow the appliance to fully cool before starting work

Replacement dishwasher seal creates a watertight connection between components. Replace when leaks or pooling occur. Verify fit with your model number.

Fix a warped or damaged dishwasher door with this inner door panel. Restores proper door fit, stops leaks and rattling. Moderate DIY repair.

Fix dishwasher spray arm not rotating with this spindle shaft. Restores proper water distribution when the rotating shaft is worn or broken.

This auxiliary service tool is used to perform specific installation and repair steps as defined by the manufacturer. It helps technicians safely engage, align, or remove components during approved procedures on compatible appliances. What it does:

• Provides the exact tool profile specified by the manufacturer for select service procedures
• Assists with controlled removal/installation of clips, springs, or fittings as directed in service literature
• Helps align or seat components during assembly to prevent damage
• Intended for use by trained servicers following the official procedure for your model

What's included: 1 auxiliary tool Install notes:

• Disconnect power and shut off water and/or gas before servicing
• Follow your model's official service manual for when and how to use this tool
• Wear protective gloves and eye protection; parts may have sharp edges or spring tension
• Keep hardware organized and correct operation and leak-free connections before restoring service

Trim strip finishes the exposed edge of your dishwasher where it installs. Replace if cracked, broken, or missing to restore a clean, finished look.

This bearing clip secures a drum/tub bearing assembly to keep the bearing properly seated, helping maintain stable drum rotation and reduce wobble. Replace a worn or broken clip to restore correct bearing alignment. What it does:

• Holds the bearing in position so the drum/tub spins smoothly
• Prevents the bearing from shifting or slipping out of its mounting
• Can help reduce noise and wobble caused by a loose bearing
• Works as part of the bearing support system for the washer/drum assembly

• Recommended for installers or experienced DIYers; the correct service panels are removed before accessing the bearing area
• Disconnect power and water supply before beginning any repair
• Inspect adjacent bearings, seals, and mounting surfaces for wear and replace as needed
• Use proper tools to avoid damaging the clip or surrounding components during removal and installation