Bosch Range HDI7032C Parts

Replacement mounting nut for securing internal oven and range components. Needed when original fastener is stripped, missing, or damaged during repair work.

Secures internal components and panels to restore proper alignment in your range. Replace when bracket is broken, cracked, or missing to fix loose parts.

Converting your range from natural gas to propane? This LP conversion kit includes correctly sized jets for safe burner operation and efficient cooking.

This is the front facia panel that mounts on the range and houses or surrounds the control knobs and displays. It provides a finished appearance to the control area and helps protect the internal wiring and components behind it. Replace this panel if it is cracked, warped, discolored from heat damage, or if mounting points are broken.

This rail guides and supports oven racks as they slide in and out of your range. Replace if bent, cracked, or missing to restore smooth rack operation.

Replace your range door seal to stop heat loss and improve oven efficiency. This rubber gasket creates an airtight barrier. Confirm fit with your model.

Replace worn or broken oven door hinges that cause misalignment or prevent proper closure. This hinge kit restores smooth door operation and fit.

Mounting hardware kit to secure range panels and components. Replace missing, stripped, or damaged fasteners to restore stable fit and eliminate rattling.

This inner door is the dishwasher's inner panel that supports the door assembly and helps contain water and steam during cycles, restoring a secure, finished door surface. It replaces damaged or corroded inner door panels to improve sealing and appearance. What it does:

• Serves as the interior face of the dishwasher door and provides structural support for inner components
• Helps maintain a watertight seal and prevents leaks from the door area
• Replaces dented, cracked, or corroded inner panels that can trap moisture or cause cosmetic damage
• Restores proper alignment so the door closes and latches correctly

• 1 inner door panel

• Disconnect power and water supply before starting any repair
• Handle panel edges carefully; use gloves to avoid cuts and protect finish
• Installation typically requires removing the outer door panel and disconnecting inner fasteners—keep hardware organized for reassembly

This flat washer secures fasteners and helps distribute load on mounting points to prevent loosening and wear. A small but essential hardware piece for reliable assembly and stable operation. What it does:

• Provides a smooth bearing surface between a fastener head or nut and the part being secured
• Helps distribute clamping force to reduce pressure on softer materials
• Reduces risk of fastener loosening from vibration or movement
• Protects mating surfaces from damage during tightening

• One flat washer

• Inspect mating fastener and surface for damage; replace parts if worn or deformed
• Slide washer onto the bolt or stud before installing the nut or fastener head
• Tighten fastener to the manufacturer's recommended torque if available
• Disconnect power and follow appliance safety procedures before accessing internal components