Bosch Range HDIP056U Parts

Replacement drawer front panel for ranges. Restores appearance and proper fit when the original is cracked, dented, scratched, or missing. Single drawer style.

Restore even baking when your oven heats unevenly. This convection fan blade circulates hot air for consistent cooking. Moderate DIY install.

This is a gas valve that controls the flow of gas to an individual surface burner on a gas range or cooktop. It connects to the burner control knob and regulates the flame from high to low settings. Replace this valve if a burner will not ignite, the flame cannot be adjusted properly, or you detect a gas smell when the knob is in the off position.

Fixes inconsistent flames or weak heating on your range. This gas pressure regulator stabilizes fuel flow to burners for reliable cooking performance.

Mounting screw for ranges and cooktops. Secures panels, brackets, and components during installation. Replace if lost, stripped, or damaged.

Replacement end cap for oven door handles. Fits at either end of the handle assembly to provide a finished look and comfortable grip. Replace if cracked or missing.

Fix intermittent power or electrical faults in your range with this cable harness. Routes power and signals between control and components. Direct fit.

Supports dishwasher door alignment and smooth opening. Replace if door sags, closes unevenly, or seals poorly. Confirm fit with your model number.

Fix burners that won't light or have intermittent ignition. This spark electrode generates the high-voltage spark needed to ignite gas burners reliably.

This replacement routing tube channels fluid inside the appliance to restore proper flow and stop leaks. It replaces a damaged, cracked, or clogged tube to help prevent water pooling and restore normal operation. What it does:

• Routes water or condensate between internal components to maintain proper drainage or flow
• Replaces cracked, split, or deteriorated tubing that can cause leaks or puddles
• Helps eliminate intermittent dripping or loss of water flow caused by blockages or holes
• Works as a direct-fit replacement when the original tubing has failed

• One replacement tube

• Disconnect power and shut off the water supply before installing
• Inspect and reuse or replace any retaining clips, clamps, or grommets as needed
• Slide tube fully into fittings and secure with appropriate clamps to prevent leaks

Burner flame uneven or won't light properly? This burner cap restores proper flame pattern and protects the burner head. Simple 5-minute replacement.

This is the inner door panel that forms the interior-facing surface of the oven door. It provides structural support for the door assembly and helps contain heat within the oven cavity. Replace this panel if it is warped, cracked, rusted, or if the oven door is not sealing properly and allowing heat to escape.

Range not heating properly or taking too long to warm up? This heating element restores proper temperature control. Moderate difficulty repair in 30-45 minutes.

This retaining washer secures a control shaft or hub to keep components in place during operation, helping restore proper control movement and prevent parts from sliding off the shaft. Simple replacement when a worn or missing retainer causes loose knobs or shifting parts. What it does:

• Fits onto a control or drive shaft to hold a knob, hub or gear in position
• Prevents axial movement that can cause loose or slipping controls
• Commonly replaced when the original washer is bent, cracked, or lost
• Works with compatible Bosch control assemblies and hubs

• One retaining washer

• Recommended for users comfortable with basic appliance disassembly; unplug appliance before starting
• Remove the control knob or panel per model instructions to access the shaft
• Press the washer into place on the shaft until fully seated; verify proper fit and control operation

Secures and supports range panels and internal assemblies. Replace if broken, bent, or missing to restore proper panel alignment and stability.