Bosch Range HDS8055U Parts

This facia panel is the exterior front trim that covers and protects the appliance's control area while restoring the unit's finished appearance. It replaces cracked, scratched, or discolored front trim for a clean, factory look. What it does

• Covers and protects the control area and electronics from spills and everyday wear
• Restores the appliance's front appearance by replacing damaged or faded trim
• Secures to the door/control assembly with factory mounting points and retains original alignment
• Common symptoms it addresses: visible cracks, chips, peeling finish, loose or warped front trim

• One facia panel (front control trim) as shown

• Disconnect power to the appliance before starting any repair
• Remove any outer trim, bezels, or door panels per the manufacturer instructions to access fasteners
• Handle edges and painted surfaces carefully to avoid cosmetic damage during installation
• Keep original screws and clips; reuse factory hardware unless replacements are specified

The Nozzle Set is an OEM component specifically designed for Bosch liquid gas ranges and cooktops. Comprised of precisely engineered nozzles, it distributes gas flow evenly across burners for consistent, controllable cooking temperatures. The nozzle set allows optimal combustion necessary for full burner functionality.

Symptoms of a faulty set include: 

• Irregular or uneven heating from certain gas outlets
• Inability to achieve desired heat levels on low to medium flames  
• Possible yellow flame tips instead of blue burning efficiently
• Reduced gas pressure output requiring replacement

Causes of a damaged nozzle set are mineral buildup and gradually reducing orifice diameter. Physical damage like cracks could also occur from improper cleaning tools over time.

Replacing with this genuine Bosch set restores balanced heating performance. Compatible with some Thermador, Gaggenau, and Dacor appliances, it supports enjoyable home-cooked meals for years to come with OEM nozzles.
 

This potentiometer is a rotary control used on select appliance control panels to adjust settings and signal the control board. It restores tactile control and accurate input for temperature or function selection. What it does:

• Converts knob rotation into a variable electrical signal the control board uses to set temperatures or cycles
• Commonly linked to symptoms like unresponsive or erratic control response and inability to change settings
• Helps eliminate intermittent contact or dead spots caused by a worn or failed control resistor
• Matches the original mounting and connector style for plug-and-play replacement when compatible

• One potentiometer

• Disconnect power (unplug or switch off breaker) before starting any repair
• Remove the control panel or back cover carefully to access the component; keep screws and small parts organized
• Reassemble and test function before fully replacing panels