Bosch Range HEIP056U Parts

Replace your oven's air duct if the original is cracked, broken, or missing. This component directs airflow within the oven cavity for proper ventilation.

Decorative trim plate that covers gaps between range components and restores finished appearance. Replace if cracked, scratched, or missing.

Mounting screw for wall ovens and ranges. Secures interior or exterior components. Replace if screw is stripped, missing, or damaged during service.

Sheet panel for wall ovens and ranges. Installs inside the oven cavity as a structural component. Replace if cracked, damaged, or missing.

This is a replacement mounting screw used to secure appliance panels and components. It provides a straightforward fix for loose or rattling parts and restores proper fit and alignment. What it does:

• Fastens panels, brackets, or small components to appliance frames
• Prevents rattling or movement caused by loose hardware
• Restores proper alignment for covers and access panels
• Works wherever the original screw size and thread match

• One replacement screw

• Match screw size and thread to the original before installation
• Use the correct driver to avoid stripping the head
• Do not overtighten; snug until secure to prevent damage
• Disconnect power or follow appliance safety procedures before accessing internal components

This cable harness routes electrical signals between dishwasher components to restore proper control and power delivery. It replaces a damaged or broken wiring assembly so affected circuits can communicate and operate reliably. What it does:

• Connects control board, sensors, pumps and other internal components to carry power and signals
• Restores intermittent or lost power to specific assemblies caused by frayed or broken wires
• Helps eliminate error codes or failures tied to open or shorted harness connections
• Prevents arcing and poor connections that can cause unreliable operation

• One cable harness assembly as pictured

• Only install after disconnecting power to the appliance to avoid shock or damage
• Inspect mating connectors and pins for corrosion or damage before connecting
• Route harness away from sharp edges, moving parts and hot surfaces to avoid future wear