Bosch Range HES256UC Parts

Mounting screw secures internal oven components and panels. Replace if stripped, missing, or damaged during service. Essential hardware for reassembly.

Replace a damaged heat shield causing nearby components to overheat or melt. This protective panel restores the heat barrier on your gas range.

Oven won't heat or reach proper temperature? This heating element restores heat generation. DIY repair takes about 30 minutes with basic tools.

Secures your range door and allows smooth pivoting for proper alignment and seal. Replace if your door won't close fully, sags, or doesn't seat correctly.

This replacement door handle restores a secure grip and smooth opening for the appliance door. It replaces a cracked, broken or loose handle so you can open and close the door confidently and safely. What it does:

• Provides a sturdy replacement grip for the appliance door to restore normal opening and closing
• Stops movement or wobble caused by worn or cracked handles
• Helps prevent sharp edges and potential injury from broken plastic
• Restores the aesthetic appearance of the door when the original handle is damaged

• One door handle

• Before starting, disconnect power to the appliance and follow any manufacturer safety steps
• Support the door while removing fasteners to avoid drop or damage
• Use basic hand tools (screwdriver, nut driver) to remove and reinstall mounting screws; do not overtighten

This is a temperature sensor used in microwave ovens to monitor internal cooking temperatures. It sends temperature readings to the control board, allowing the appliance to regulate heating accurately. Replace this sensor if the microwave overheats, shuts off prematurely, displays error codes related to temperature, or fails to cook food to the correct temperature.

This rail guides and supports oven racks as they slide in and out of your range. Replace if bent, cracked, or missing to restore smooth rack operation.

Mounting screw for gas ranges, wall ovens, and range installations. Used to secure panels, brackets, or internal components. Replace if missing or stripped.

This inner door is the dishwasher's inner panel that supports the door assembly and helps contain water and steam during cycles, restoring a secure, finished door surface. It replaces damaged or corroded inner door panels to improve sealing and appearance. What it does:

• Serves as the interior face of the dishwasher door and provides structural support for inner components
• Helps maintain a watertight seal and prevents leaks from the door area
• Replaces dented, cracked, or corroded inner panels that can trap moisture or cause cosmetic damage
• Restores proper alignment so the door closes and latches correctly

• 1 inner door panel

• Disconnect power and water supply before starting any repair
• Handle panel edges carefully; use gloves to avoid cuts and protect finish
• Installation typically requires removing the outer door panel and disconnecting inner fasteners—keep hardware organized for reassembly

This flat washer secures fasteners and helps distribute load on mounting points to prevent loosening and wear. A small but essential hardware piece for reliable assembly and stable operation. What it does:

• Provides a smooth bearing surface between a fastener head or nut and the part being secured
• Helps distribute clamping force to reduce pressure on softer materials
• Reduces risk of fastener loosening from vibration or movement
• Protects mating surfaces from damage during tightening

• One flat washer

• Inspect mating fastener and surface for damage; replace parts if worn or deformed
• Slide washer onto the bolt or stud before installing the nut or fastener head
• Tighten fastener to the manufacturer's recommended torque if available
• Disconnect power and follow appliance safety procedures before accessing internal components