Bosch Range HGI8046UC Parts

The Screw is an OEM part for Bosch gas cooktops and ranges. It anchors the surface burner head assembly onto the cooktop surface.

Causes can be stripped threads or overall wear from repeated heating/cooling cycles. Exposure to cooking spills or impacts may also deteriorate the screw head over time.

Symptoms of a bad burner head screw include:

• A burner detaching from the cooktop surface entirely
• Excess movement or instability of burner heads when in use
• Gas leaks reported around the burner head connection points

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This water inlet valve controls the flow of water into the appliance, restoring proper filling and preventing overfill when working correctly. Fits specific BOSCH machines and replaces a worn or failed inlet valve. What it does:

• Opens and closes to allow water into the appliance when a cycle calls for fill
• Helps maintain correct water level so cycles run and clean properly
• Failsafe against continuous fill when functioning correctly; common fault causes no-fill or constant-fill symptoms
• Often replaced when appliance leaks, won't fill, or runs continuously without stopping

• One water inlet valve

• Disconnect power and shut off water supply before attempting replacement
• Handle electrical connections and inlet lines carefully; inspect seals and hoses and replace if worn

This is a 6-inch drip bowl that sits beneath the surface burner element on an electric range or cooktop. It catches spills and drips while reflecting heat upward toward the cookware for more efficient heating. Replace this drip bowl if it is warped, corroded, heavily stained, or no longer sitting flat under the burner element.

Replaces cracked, chipped, or fogged oven door inner glass. Restores clear viewing and proper heat retention. Confirm fit with your model number.

The Screw is an OEM part for Bosch microwave ovens. It is a component that secures the outer casing and front paneling of the microwave. The screw is designed to withstand repeated heating and cooling cycles without loosening or degrading. 

Symptoms of bad screw include:

- The front panel or outer casing becoming loose, detached, or misaligned
- Gaps appearing in the seams or joints of the microwave structure
- The door not sealing properly leading to leaks

Over many uses of the microwave, screws can wear down or strip out from over-tightening during repairs or installations. It is important to replace worn screws to ensure the microwave maintains an intact structure.

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.
 

Halogen oven light bulb illuminates the oven cavity for clear viewing during cooking. Replace when dim or burned out. Verify fit with your model.

Range not responding to controls or experiencing intermittent operation? This cable harness restores power and signal connections between components.

A programmed electronic control module that restores appliance control functions by replacing a failed main board. This factory-programmed module arrives ready to install to help get your appliance responding and running normally. What it does:

• Replaces the appliance's main electronic controller to restore user controls and cycle operation.
• Addresses symptoms like unresponsive buttons, display errors, or failure to start when the original control board is faulty.
• Manages timed cycles, sensors, and signals between components to maintain normal operation.
• Designed as a direct-replacement programmed unit to reduce setup steps.

• One programmed control module (single unit)

• Disconnect power to the appliance before attempting replacement to avoid shock or short circuits.
• Handle the module by its edges and avoid contact with connector pins or circuit traces.
• Verify cabinet access procedure for your model; control location and mounting vary by appliance type.

Replacement mounting screw for securing panels, brackets, and components in ranges and wall ovens. Restores proper fit if original is missing or stripped.

This small rubber ring seals the gap between the control knob and the range surface, preventing spills and debris from entering the control mechanism. Replace when the gasket becomes cracked, torn, or missing, allowing liquids to seep behind the control panel or causing the knob to feel loose.

The Insert is an OEM part for Bosch ovens. It secures and stabilizes the oven door handle, ensuring proper alignment and smooth operation.

This insert is engineered to withstand the rigors of regular use, providing a stable and reliable connection between the oven door and the handle.  

Causes of a bad mounting insert can include excessive wear and tear, exposure to high temperatures or moisture, or physical impact that may cause deformation or cracking.

Symptoms of a bad insert include:

• Loose or wobbly door handle
• Difficulty in opening or closing the oven door smoothly
• Misalignment of the handle with the door
• Potential damage to the handle or door due to improper support

This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore models.

The Burner is an OEM part for Bosch ranges and cooktops. The burner head features precision engineered ports that allow for the proper mixing of gas and air, ensuring efficient and even combustion.

Causes of a bad gas burner head can include clogging or blockages of the small flame ports, cracks or breaks in the metal head casing from long term heat exposure or accidental damage.

Symptoms of a bad gas burner head include:

• Uneven or irregular flame patterns
• Flames that blow out easily or are difficult to ignite
• Reduced heating power and ineffective cooking
• Gas leaks from cracks or breaks in the head casing

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

Replacement mounting nut for securing internal oven and range components. Needed when original fastener is stripped, missing, or damaged during repair work.

Restore even baking when your oven heats unevenly. This convection fan blade circulates hot air for consistent cooking. Moderate DIY install.

Fix intermittent power or electrical faults in your range with this cable harness. Routes power and signals between control and components. Direct fit.

Replace clogged or cracked spray jets to restore water distribution and cleaning performance. Direct-fit nozzles for dishwasher spray arms. Verify model fit.