Bosch Range HGI8056UC Parts

Fix intermittent power or electrical faults in your range with this cable harness. Routes power and signals between control and components. Direct fit.

Replace clogged or cracked spray jets to restore water distribution and cleaning performance. Direct-fit nozzles for dishwasher spray arms. Verify model fit.

Mounting screw for ranges and cooktops. Secures panels, brackets, and components during installation. Replace if lost, stripped, or damaged.

Secures flexible hoses to fittings on your range to prevent leaks. Replace if connections are loose or clamp is damaged. Verify fit with your model.

Replacement end cap for oven door handles. Fits at either end of the handle assembly to provide a finished look and comfortable grip. Replace if cracked or missing.

Single replacement mounting screw for securing gas range panels, trim pieces, and brackets. Needed when original screw is stripped, lost, or damaged during repair.

Door seal gasket that creates a heat-tight barrier around the oven door perimeter. Prevents heat escape during cooking. Replace if torn, hardened, or oven loses heat.

Replacement tube that channels water inside the appliance to restore proper flow and help prevent leaks, pooling, or poor performance when the original is cracked, kinked, or deteriorated for reliable operation. What it does:

• Routes water between internal components to maintain normal circulation.
• Stops properly when replaced if the original is cracked, split, hardened, or leaking.
• Common symptoms indicating replacement: visible leaks, puddling under the appliance, reduced water flow, or inconsistent cycle performance.
• Reinstall with proper clamps and routing to avoid kinks and ensure a watertight connection.

• Disconnect power and shut off the water supply before starting any repair.
• Drain remaining water and relieve pressure in lines to minimize spills.
• Remove access panels as needed and note the tube routing/orientation before removing the old part.
• Install the new tube without sharp bends, secure with the correct clamps or fittings, then restore power/water and check thoroughly for leaks.

This water inlet valve controls the flow of water into the appliance, restoring proper filling and preventing overfill when working correctly. Fits specific BOSCH machines and replaces a worn or failed inlet valve. What it does:

• Opens and closes to allow water into the appliance when a cycle calls for fill
• Helps maintain correct water level so cycles run and clean properly
• Failsafe against continuous fill when functioning correctly; common fault causes no-fill or constant-fill symptoms
• Often replaced when appliance leaks, won't fill, or runs continuously without stopping

• One water inlet valve

• Disconnect power and shut off water supply before attempting replacement
• Handle electrical connections and inlet lines carefully; inspect seals and hoses and replace if worn

This control panel cover protects the dishwasher's electronic controls and wiring behind the front panel, helping keep moisture and debris away while restoring a clean, finished appearance. Fits the OEM location where the control board is housed. What it does:

• Shields control board and wiring from steam, splashes, and food debris
• Helps prevent intermittent faults caused by moisture exposure
• Restores a secure mounting surface for the front control assembly
• Improves appliance appearance if original cover is cracked or damaged

• Disconnect power to the appliance before starting any repair.
• Remove the outer door panel or control trim per your model's service instructions to access the cover.
• Retain any screws or clips from the original part for reinstallation unless replacements are supplied separately.

This replacement routing tube channels fluid inside the appliance to restore proper flow and stop leaks. It replaces a damaged, cracked, or clogged tube to help prevent water pooling and restore normal operation. What it does:

• Routes water or condensate between internal components to maintain proper drainage or flow
• Replaces cracked, split, or deteriorated tubing that can cause leaks or puddles
• Helps eliminate intermittent dripping or loss of water flow caused by blockages or holes
• Works as a direct-fit replacement when the original tubing has failed

• One replacement tube

• Disconnect power and shut off the water supply before installing
• Inspect and reuse or replace any retaining clips, clamps, or grommets as needed
• Slide tube fully into fittings and secure with appropriate clamps to prevent leaks

Range not heating properly or taking too long to warm up? This heating element restores proper temperature control. Moderate difficulty repair in 30-45 minutes.

This small rubber ring seals the gap between the control knob and the range surface, preventing spills and debris from entering the control mechanism. Replace when the gasket becomes cracked, torn, or missing, allowing liquids to seep behind the control panel or causing the knob to feel loose.

This replacement door gasket seals the dishwasher door to keep water inside the tub and help maintain wash performance. It restores a tight door seal to reduce leaks and prevent water from pooling around the appliance. What it does:

• Creates a watertight seal between the door and tub to stop leaks during cycles
• Helps prevent water from dripping onto floors and surrounding cabinetry
• Reduces steam and moisture escape that can cause odors or damage
• Restores proper door closure where worn or flattened seals allow seepage

• Disconnect power and water supply before attempting any service.
• Inspect surrounding door edges for damage and clean mounting surfaces before installing the new gasket.
• Press the gasket firmly into the door channel; some models require partial door disassembly.
• After installation, run a short cycle and check for leaks before returning the dishwasher to regular use.

Replacement trim panel insert that restores your oven's finished appearance. Replaces cracked, warped, or missing trim pieces. Fits into assembly for flush exterior.

Fix weak or uneven burner flames with this gas range pressure regulator. Controls gas flow for consistent cooking performance and safe operation.