Bosch Range HGI8056UC Parts

Oven light bulb illuminates the cavity for monitoring food without opening the door. Replace when burned out or flickering. Verify fit with your model.

Fixes uneven flames and weak heating on gas range burners. This surface burner head restores proper flame distribution for consistent cooking performance.

Mounting screw for gas ranges and warming drawers. Secures components and panels in place. Replace if screw is stripped, missing, or broken.

The Cooktop is an OEM part for Bosch gas ranges and cooktops. As the main cooking surface, the gas cooktop withstands extreme heat levels across its burners and grates on a daily basis.

Causes of cooktop deterioration stem from prolonged heat cycling combined with debris accumulation over many years. Accidental impact or surface damage from improper cleaning can also crack components prematurely.

Symptoms of a damaged cooktop include:

• Uneven or irregular burner flame patterns that waste fuel
• Hot spots creating risks of scorching or burning food
• Grates or surface areas pitted or corroded beyond repair
• Detached or damaged burner caps impacting performance

This genuine OEM Bosch part is also compatible with Thermador, Gaggenau and select Kenmore models.

This retaining washer secures a control shaft or hub to keep components in place during operation, helping restore proper control movement and prevent parts from sliding off the shaft. Simple replacement when a worn or missing retainer causes loose knobs or shifting parts. What it does:

• Fits onto a control or drive shaft to hold a knob, hub or gear in position
• Prevents axial movement that can cause loose or slipping controls
• Commonly replaced when the original washer is bent, cracked, or lost
• Works with compatible Bosch control assemblies and hubs

• One retaining washer

• Recommended for users comfortable with basic appliance disassembly; unplug appliance before starting
• Remove the control knob or panel per model instructions to access the shaft
• Press the washer into place on the shaft until fully seated; verify proper fit and control operation

Secures and supports range panels and internal assemblies. Replace if broken, bent, or missing to restore proper panel alignment and stability.

Replacement mounting screw for ranges and wall ovens. Secures panels, brackets, and assemblies in place. Needed when original is lost, stripped, or damaged.

This front panel is the exterior door trim that restores your appliance's finished appearance and protects internal components from everyday wear. It replaces a damaged, bent, or cosmetically worn front surface to help the appliance look and seal properly. What it does:

• Covers and protects the appliance door area and internal components from damage and debris.
• Restores the appliance's finished appearance after dents, scratches, or faded paint.
• Re-establishes proper fit and edge alignment when the original panel is bent or warped.
• Helps maintain a consistent seal and gap appearance along the door perimeter.

• Disconnect power (and water if applicable) before beginning any work.
• Remove door or control trim to access mounting fasteners; retain all screws and clips.
• Handle edges carefully to avoid cuts or damaging the finish; use appropriate trim tools.
• If mounting tabs or clips are broken, replace them before installing the panel to ensure proper fit.

Internal wiring cable for gas ranges. Connects electrical components inside your range. Replace if frayed, damaged, or broken to restore proper connections.

This spacer is a small structural component that maintains proper clearance between oven parts. Replace if broken, missing, or worn to ensure correct spacing.

Mounting screw that secures panels and internal components in your range. Replace if screw is lost, stripped, or worn to restore secure fit and stop rattling.