Bosch Range HGI8056UC Parts

Mounting screw for electric and gas ranges and wall ovens. Secures internal components and panels. Replace if missing, stripped, or damaged during repair.

Covers and finishes your range control panel area, protecting internal controls from dirt and spills. Replace when cracked or discolored. Verify fit.

Replaces cracked or damaged rear housing cover on your range. Protects internal components and ensures proper ventilation through integrated vents.

This front panel is the exterior door trim that restores your appliance's finished appearance and protects internal components from everyday wear. It replaces a damaged, bent, or cosmetically worn front surface to help the appliance look and seal properly. What it does:

• Covers and protects the appliance door area and internal components from damage and debris.
• Restores the appliance's finished appearance after dents, scratches, or faded paint.
• Re-establishes proper fit and edge alignment when the original panel is bent or warped.
• Helps maintain a consistent seal and gap appearance along the door perimeter.

• Disconnect power (and water if applicable) before beginning any work.
• Remove door or control trim to access mounting fasteners; retain all screws and clips.
• Handle edges carefully to avoid cuts or damaging the finish; use appropriate trim tools.
• If mounting tabs or clips are broken, replace them before installing the panel to ensure proper fit.

This flat washer secures fasteners and helps distribute load on mounting points to prevent loosening and wear. A small but essential hardware piece for reliable assembly and stable operation. What it does:

• Provides a smooth bearing surface between a fastener head or nut and the part being secured
• Helps distribute clamping force to reduce pressure on softer materials
• Reduces risk of fastener loosening from vibration or movement
• Protects mating surfaces from damage during tightening

• One flat washer

• Inspect mating fastener and surface for damage; replace parts if worn or deformed
• Slide washer onto the bolt or stud before installing the nut or fastener head
• Tighten fastener to the manufacturer's recommended torque if available
• Disconnect power and follow appliance safety procedures before accessing internal components