Bosch Range HII8046U Parts

This is a spacer insert that fits behind or between the oven door handle and the outer door panel, ensuring the handle is properly positioned and securely mounted. It helps maintain the correct gap and alignment for the door handle assembly. Replace this part if the door handle feels loose, sits unevenly, or if the original spacer is cracked or missing.

Secures the door hinge assembly to the oven cabinet frame. Replace if the original holder is cracked, broken, or missing to restore proper door alignment.

Replacement control panel for electric and gas ranges. Installs on the front of the appliance. Needed when the original panel is cracked, damaged, or worn.

Mounting screw secures internal oven components and panels. Replace if stripped, missing, or damaged during service. Essential hardware for reassembly.

Mounting screw for electric and gas ovens and ranges. Secures internal components and panels. Replace if missing, stripped, or damaged during service.

Mounting screw for wall ovens and ranges. Secures interior or exterior components. Replace if screw is stripped, missing, or damaged during service.

Fix a cooktop that won't heat, has unresponsive controls, or shows error codes with this electronic control board. Moderate difficulty repair.

This is a replacement mounting screw used to secure appliance panels and components. It provides a straightforward fix for loose or rattling parts and restores proper fit and alignment. What it does:

• Fastens panels, brackets, or small components to appliance frames
• Prevents rattling or movement caused by loose hardware
• Restores proper alignment for covers and access panels
• Works wherever the original screw size and thread match

• One replacement screw

• Match screw size and thread to the original before installation
• Use the correct driver to avoid stripping the head
• Do not overtighten; snug until secure to prevent damage
• Disconnect power or follow appliance safety procedures before accessing internal components

Replacement control panel cover for your cooktop. Installs over the control area to protect electronics. Replace if cracked, broken, or missing.

This cable harness routes electrical signals between dishwasher components to restore proper control and power delivery. It replaces a damaged or broken wiring assembly so affected circuits can communicate and operate reliably. What it does:

• Connects control board, sensors, pumps and other internal components to carry power and signals
• Restores intermittent or lost power to specific assemblies caused by frayed or broken wires
• Helps eliminate error codes or failures tied to open or shorted harness connections
• Prevents arcing and poor connections that can cause unreliable operation

• One cable harness assembly as pictured

• Only install after disconnecting power to the appliance to avoid shock or damage
• Inspect mating connectors and pins for corrosion or damage before connecting
• Route harness away from sharp edges, moving parts and hot surfaces to avoid future wear