Bosch Freezer KAD62P90 Parts

The Motor is an OEM part for Bosch refrigerators. This motor is specifically designed to power the ice dispenser mechanism, allowing for the convenient dispensing of ice cubes or crushed ice. It delivers the necessary power to rotate the dispenser auger, providing you with a steady supply of ice whenever you need it.

A bad motor can occur due to wear and tear, electrical malfunctions, or motor failure. Signs of a faulty motor include the ice dispenser not working, the auger not rotating, or unusual grinding or buzzing noises during ice dispensing.

Symptoms of a bad motor include:

• Inability to dispense ice  
• Noisy or erratic operation 

Replace your malfunctioning or worn-out ice dispenser motor with this genuine OEM Bosch part to restore your refrigerator's ice dispenser. This Bosch part can also be used on Thermador and Gaggenau appliances.
 

The adjusting screw allows you to level your refrigerator and adjust door alignment, typically located at the base of the unit. Replace when the screw becomes stripped, corroded, or can no longer properly support or adjust the refrigerator.

This door seal fits around the dishwasher tub opening to keep water and steam inside during cycles. Replacing a worn gasket restores a tight seal so the door latches properly and helps prevent leaks at the sides or bottom.

• Creates a watertight barrier between the door and tub during wash and rinse cycles
• Helps contain steam and reduce moisture escaping from the front of the unit
• Replaces a flattened, cracked, torn, or deformed seal that can cause leaks
• Common symptoms include drips at the front edge, water on the floor near the door, and needing extra force to latch

• Disconnect power and, if applicable, shut off the water supply before servicing
• Pull the old seal from the channel; clean the groove and mating surfaces thoroughly
• Press the new seal in evenly without stretching; seat corners fully and position the joint at the bottom center
• Close the door to help the seal set; a snug fit at first is normal

This is a flexible rubber seal that attaches around the perimeter of the freezer door, creating an airtight closure when the door is shut. It prevents warm air from entering the freezer compartment and keeps cold air from escaping. Replace this gasket if you notice frost buildup inside the freezer, the door does not seal tightly, the gasket is torn or warped, or the compressor runs more frequently than normal.

This is an electrical on/off switch used to control power to an appliance circuit. It replaces a failed switch so controls respond normally and the appliance can be powered on and off safely. What it does

• Opens and closes an electrical circuit to enable or disable appliance power or a specific control function
• Commonly replaces a worn, stuck, or unresponsive switch that prevents controls or lights from operating
• Can resolve symptoms like no power to a control, intermittent operation, or a button that won't actuate
• Designed to mate with the appliance's existing wiring and mounting points

• One electrical on/off switch

• Disconnect power to the appliance at the breaker or unplug before working on wiring
• Verify proper wire locations and secure all terminal connections; replace only with the exact part specified by the manufacturer
• Handle the part carefully to avoid bending terminals or damaging the switch actuator

Replacement interior tray for your refrigerator. Restores a flat, stable surface for holding items. Replace if cracked, broken, or missing.

Replacement outer door frame trim for refrigerators. Secures control panel and exterior panel in place. Needed when original frame is cracked, warped, or damaged.

This door switch senses the dishwasher door position and tells the control when the door is closed so cycles can start or stop. It restores proper door sensing for reliable operation and safety. What it does:

• Detects when the door is fully closed so the control can begin or continue a wash cycle
• Prevents the dishwasher from starting or running when the door is open
• Common fix for symptoms like no-start, intermittent power to controls, or cycles that stop when the door moves
• Works with the latch/strike assembly to ensure a secure door closure signal

• One door switch

• Always disconnect power at the breaker or unplug the appliance before servicing
• Access typically requires removing the inner door panel; handle the inner door and glass carefully
• Verify wiring orientation and gently disconnect connectors; replace with identical wiring and secure all fasteners
• Test door operation before reassembling the door panels

If your refrigerator isn't cooling properly or cycles too frequently, the accumulator may need replacement. Protects the compressor from liquid refrigerant.

This replacement cutlery tray fits into the dishwasher's third rack to organize and secure silverware and small items for better cleaning and to prevent nesting or damage during cycles. What it does:

• Provides a dedicated area to lay forks, knives and spoons flat so water reaches all surfaces
• Helps prevent utensils from falling through or clumping together during a wash
• Maintains proper spacing to improve wash performance for small items
• Replaces a cracked, warped or missing third-rack tray that can allow items to shift or block spray

• Remove and reinstall on the third-rack rails; no tools typically required
• Ensure tray locks or rests fully in the rack before running the dishwasher
• Inspect for broken tabs or sharp edges and handle carefully to avoid cuts
• Disconnect power and your dishwasher's user manual or parts diagram about placement

Replace a cracked, worn, or missing washer in your refrigerator. This small part provides proper spacing and cushioning between components during assembly.

Left-side mounting clip secures refrigerator door panel to frame, preventing rattles and maintaining proper alignment. Replace when worn or broken to ensure even door closure and tight seal.

Secures the right-side door track assembly for smooth operation and proper alignment. Replace if cracked, broken, or missing to restore panel fit.

Replacement door stop for your refrigerator. Installs on the door or cabinet to prevent damage. Order a new stop if yours is broken, cracked, or missing.