Bosch Freezer KAD62S20SD Parts

The Motor is an OEM part for Bosch refrigerators. This motor is specifically designed to power the ice dispenser mechanism, allowing for the convenient dispensing of ice cubes or crushed ice. It delivers the necessary power to rotate the dispenser auger, providing you with a steady supply of ice whenever you need it.

A bad motor can occur due to wear and tear, electrical malfunctions, or motor failure. Signs of a faulty motor include the ice dispenser not working, the auger not rotating, or unusual grinding or buzzing noises during ice dispensing.

Symptoms of a bad motor include:

• Inability to dispense ice  
• Noisy or erratic operation 

Replace your malfunctioning or worn-out ice dispenser motor with this genuine OEM Bosch part to restore your refrigerator's ice dispenser. This Bosch part can also be used on Thermador and Gaggenau appliances.
 

Fixes no water dispensing or slow ice production. This refrigerator water tank stores water for the dispenser and ice maker. DIY-friendly repair.

This door seal fits around the dishwasher tub opening to keep water and steam inside during cycles. Replacing a worn gasket restores a tight seal so the door latches properly and helps prevent leaks at the sides or bottom.

• Creates a watertight barrier between the door and tub during wash and rinse cycles
• Helps contain steam and reduce moisture escaping from the front of the unit
• Replaces a flattened, cracked, torn, or deformed seal that can cause leaks
• Common symptoms include drips at the front edge, water on the floor near the door, and needing extra force to latch

• Disconnect power and, if applicable, shut off the water supply before servicing
• Pull the old seal from the channel; clean the groove and mating surfaces thoroughly
• Press the new seal in evenly without stretching; seat corners fully and position the joint at the bottom center
• Close the door to help the seal set; a snug fit at first is normal

This is a flexible rubber seal that attaches around the perimeter of the freezer door, creating an airtight closure when the door is shut. It prevents warm air from entering the freezer compartment and keeps cold air from escaping. Replace this gasket if you notice frost buildup inside the freezer, the door does not seal tightly, the gasket is torn or warped, or the compressor runs more frequently than normal.

Restores smooth door operation and proper alignment on your refrigerator. Replace when doors wobble, bind, or make noise during opening and closing.

This filter is installed inside or near the crisper drawer compartment to help regulate humidity levels and keep fruits and vegetables fresh longer. It works by controlling airflow and moisture within the drawer. Replace this filter if your produce is wilting or spoiling faster than expected, or if the filter appears dirty or degraded.

Ice dispenser producing large clumps or blocking? This crusher assembly grinds ice into smaller, usable pieces, restoring smooth ice flow and delivery.

This door switch senses the dishwasher door position and tells the control when the door is closed so cycles can start or stop. It restores proper door sensing for reliable operation and safety. What it does:

• Detects when the door is fully closed so the control can begin or continue a wash cycle
• Prevents the dishwasher from starting or running when the door is open
• Common fix for symptoms like no-start, intermittent power to controls, or cycles that stop when the door moves
• Works with the latch/strike assembly to ensure a secure door closure signal

• One door switch

• Always disconnect power at the breaker or unplug the appliance before servicing
• Access typically requires removing the inner door panel; handle the inner door and glass carefully
• Verify wiring orientation and gently disconnect connectors; replace with identical wiring and secure all fasteners
• Test door operation before reassembling the door panels

If your refrigerator isn't cooling properly or cycles too frequently, the accumulator may need replacement. Protects the compressor from liquid refrigerant.

Access panel cover for refrigerators. Protects internal components and wiring. Replace if cracked, broken, or missing to restore appearance and shield parts.

Replace your broken or missing refrigerator shelf holder. This support piece secures shelves in place. Essential when holders crack or wear out over time.

Replacement mounting screw for refrigerator assemblies. Secures internal components and panels. Order if original is stripped, lost, or damaged.

Replacement egg rack for refrigerator door storage. Holds eggs securely in place. Order a new rack if yours is cracked, broken, or missing pieces.

Water dispenser outlet for your refrigerator. Installs at the dispenser to direct water flow. Replace if cracked, broken, or leaking around the outlet.

Replace the cover panel on your refrigerator if it's cracked, broken, or missing. This cosmetic component installs on the exterior for a complete look.