Bosch Freezer KAD62S21TI Parts

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Refrigerator not cooling properly or running too warm? This fan motor powers the blower to circulate air and maintain proper temperatures throughout your fridge.

Fixes no water dispensing or slow ice production. This refrigerator water tank stores water for the dispenser and ice maker. DIY-friendly repair.

This door seal fits around the dishwasher tub opening to keep water and steam inside during cycles. Replacing a worn gasket restores a tight seal so the door latches properly and helps prevent leaks at the sides or bottom.

• Creates a watertight barrier between the door and tub during wash and rinse cycles
• Helps contain steam and reduce moisture escaping from the front of the unit
• Replaces a flattened, cracked, torn, or deformed seal that can cause leaks
• Common symptoms include drips at the front edge, water on the floor near the door, and needing extra force to latch

• Disconnect power and, if applicable, shut off the water supply before servicing
• Pull the old seal from the channel; clean the groove and mating surfaces thoroughly
• Press the new seal in evenly without stretching; seat corners fully and position the joint at the bottom center
• Close the door to help the seal set; a snug fit at first is normal

Replacement outer door frame trim for refrigerators. Secures control panel and exterior panel in place. Needed when original frame is cracked, warped, or damaged.

Restores smooth door operation and proper alignment on your refrigerator. Replace when doors wobble, bind, or make noise during opening and closing.

Access panel cover for refrigerators. Protects internal components and wiring. Replace if cracked, broken, or missing to restore appearance and shield parts.

Ice dispenser producing large clumps or blocking? This crusher assembly grinds ice into smaller, usable pieces, restoring smooth ice flow and delivery.

Replace your broken or missing refrigerator shelf holder. This support piece secures shelves in place. Essential when holders crack or wear out over time.

Replacement mounting screw for refrigerator assemblies. Secures internal components and panels. Order if original is stripped, lost, or damaged.

Replacement egg rack for refrigerator door storage. Holds eggs securely in place. Order a new rack if yours is cracked, broken, or missing pieces.

Water dispenser outlet for your refrigerator. Installs at the dispenser to direct water flow. Replace if cracked, broken, or leaking around the outlet.

Replace the cover panel on your refrigerator if it's cracked, broken, or missing. This cosmetic component installs on the exterior for a complete look.

Directs water into your refrigerator with a secure connection. Replace if you notice leaks or loose fitting at the inlet. Confirm fit with your model number.