Bosch Range RGM8058UC Parts

This replacement upper-rack grid supports dishes and glassware so items stay upright and separate during wash cycles. Restores proper spacing and prevents movement that can cause poor cleaning or chipping. What it does:

• Provides stable support for plates, cups and small items in the upper dishwasher rack
• Maintains correct spacing so spray arms can reach dishes for effective cleaning
• Prevents dishes from shifting and colliding during wash cycles, reducing chips and breakage
• Replaces worn, cracked or missing upper-rack grid sections that allow items to fall through

• One upper-rack grid section as pictured

• High-level replacement — no special tools usually required; inspect rack clips or rail ends before reassembly
• Turn off and disconnect power to the dishwasher before performing repairs
• Handle edges carefully; avoid forcing parts to prevent further damage
• If fastening hardware is included, use only the supplied pieces; replace broken clips or mounts as needed

This replacement burner pipe routes gas from the manifold to the burner for safe combustion, restoring proper burner operation and consistent heat output. Use when a cracked, corroded, or blocked pipe prevents ignition or causes uneven flames. What it does:

• Delivers gas from the manifold to the burner for stable flame and reliable heating
• Replaces damaged, corroded, or clogged piping that can cause ignition failure or weak/uneven flames
• Helps restore proper gas flow and consistent burner performance after wear or damage
• Works with the appliance's existing manifold and burner assembly to re-establish safe operation

• Turn off gas supply and disconnect power before beginning work; follow appliance shutdown procedures
• Inspect fittings and gaskets; replace any damaged seals to ensure a gas-tight connection
• Tighten connections to manufacturer torque specs and test for leaks with a soap solution or gas leak detector

This facia panel is the front control trim that restores the dishwasher's exterior appearance and provides a finished surface for the control buttons and display. It replaces damaged, cracked, or worn front panels for a clean, like-new look. What it does:

• Replaces the outer control-facing panel that covers and protects the control buttons and display
• Restores proper alignment and appearance of the door/control area
• Helps prevent moisture and debris from reaching internal control components
• Commonly used when the front panel is cracked, chipped, scratched, or cosmetically worn

• One facia panel

• Requires basic hand tools; handle panel carefully to avoid scratching the finish
• Disconnect power to the appliance before starting work to prevent shock or accidental activation
• Keep screws and small fasteners organized during removal and reassembly

This rear case housing replaces the damaged or worn outer rear housing that protects internal components and maintains dishwasher structure. Restores proper enclosure to help reduce vibration and prevent exposure of electrical parts. What it does:

• Covers and protects motor, wiring, and internal components at the back of the appliance
• Helps maintain correct alignment and mounting for rear-mounted assemblies
• Reduces noise and vibration caused by loose or damaged housing
• Prevents incidental contact with internal electrical parts and plumbing connections
• If the existing housing is cracked, warped, or has mounting points broken

• Disconnect power and water supply before beginning any repair
• Replacement typically requires removing the dishwasher access panels and detaching rear-mounted components; have basic hand tools ready
• Handle carefully to avoid damaging tabs or mounting points during installation
• Refer to OEM installation instructions for model-specific guidance