Bosch Dishwasher SHP65CM2N Parts

Replace your dishwasher's upper rack pull-out rail assembly. Installs on top rack to enable smooth sliding. Needed when rails are cracked, broken, or wheels are worn. Includes left and right sides.

Trim strip finishes the exposed edge of your dishwasher where it installs. Replace if cracked, broken, or missing to restore a clean, finished look.

Does your dishwasher shake or make loud noises during the wash cycle? A worn suspension damper may be the cause. This part absorbs vibration and stabilizes the tub.

This insulating part provides a non-conductive, heat-resistant barrier between adjacent components inside the appliance. Replacing a damaged insulator helps prevent unintended contact and heat transfer, supporting safe, reliable operation and protecting nearby parts. What it does:

• Electrically isolates terminals or metal surfaces to help prevent shorts or arcing
• Reduces heat transfer to surrounding components
• Maintains proper spacing and support for the protected component
• Replace if the original is cracked, deformed, missing, or shows burn/discoloration

• 1 insulating part

• Disconnect power before servicing; shut off gas or water if applicable
• Access the component, note orientation/positioning of the original insulator, and transfer any clips or hardware as required
• Seat the new insulator fully and ensure no conductive parts touch unintended surfaces
• Reassemble, restore power, and verify normal operation with no rubbing, arcing, or overheating

This outer door panel replaces a damaged or dented dishwasher exterior to restore appearance and protect internal door components. It provides the finished front surface for the appliance door and helps ensure proper sealing and alignment. What it does:

• Replaces a dented, cracked, or scratched outer door surface to restore the dishwasher's exterior look
• Protects inner door parts from damage and wear
• Helps the door sit and align correctly for proper opening and closing
• Addresses cosmetic issues that can lead to customer dissatisfaction

• One outer door panel

• Disconnect power to the appliance before starting any repairs
• Support the door while removing hinge screws and fasteners to avoid dropping or bending the new panel
• Transfer any brackets, handles, trim, or insulation from the old door to the new panel
• Check door alignment and latch operation after installation; adjust hinges per manufacturer guidance if needed

Replace your dishwasher's front cabinet trim frame if cracked, broken, or missing. Restores clean appearance and secures control panel alignment.

Dishwasher pump bearing supports motor shaft rotation. Replace if you hear grinding noise or water isn't circulating properly. Verify fit with your model number.

Replacement access panel cover for your dishwasher. Restores proper fit when the original is cracked, broken, or missing. Protects internal components.

Replacement silverware basket insert for your dishwasher lower rack. Order a new insert if yours is cracked, broken, or missing to organize utensils.

Protective cover for dishwasher interior components. Replaces cracked, broken, or missing covers. Shields internal parts from water and debris.

A replacement door handle that restores a secure grip and smooth opening for the appliance door. Designed to match the original fit so the door opens and closes reliably. What it does:

• Replaces a worn, cracked, or broken door handle to restore normal opening and closing
• Provides a sturdy grip to prevent slippage or difficulty pulling the door
• Helps eliminate rattling or loose-handle noise caused by a damaged handle
• Matches the original mounting points for proper alignment and operation

• Disconnect power to the appliance before starting any repair to avoid electrical hazard
• Remove any trim or inner door panels as required to access mounting screws; keep fasteners organized
• Inspect mounting clips and screws; reuse only if in good condition or replace with manufacturer-specified hardware