Bosch Dishwasher SHP865WD2N Parts

Secures internal dishwasher components and keeps assemblies aligned. Replace this mounting clip holder if yours is cracked, broken, or missing.

Insulating pad for dishwashers. Installs on the tub or door to reduce noise and retain heat. Replace if cracked, torn, or missing for proper insulation.

Replace worn or broken control panel buttons to restore manual operation and a clean finish. Swap in when buttons stick, crack, or fall off. Confirm fit with your dishwasher model number before ordering.

Replace cracked, broken, or missing dishwasher rack roller wheels. Snaps onto bottom or top rack to restore smooth gliding. Easy DIY installation.

Replace your broken or cracked dishwasher detergent dispenser door lid. This cover installs on the dispenser compartment to keep detergent secure.

Trim strip finishes the exposed edge of your dishwasher where it installs. Replace if cracked, broken, or missing to restore a clean, finished look.

Fixes dishwasher leaking or overfilling issues. This overflow tube redirects excess water back into the drain path. Simple DIY repair part.

Does your dishwasher shake or make loud noises during the wash cycle? A worn suspension damper may be the cause. This part absorbs vibration and stabilizes the tub.

Replace your dishwasher's front cabinet trim frame if cracked, broken, or missing. Restores clean appearance and secures control panel alignment.

Upper drawer silverware insert for Bosch dishwashers. Organizes flatware and small utensils during wash cycles. Replace if cracked, broken, or missing.

Replacement screw for securing dishwasher panels, trim pieces, and brackets. Restores proper fit when original screws are stripped, lost, or damaged.

Insulating strip shields dishwasher wiring from heat and abrasion. Replace if frayed, brittle, or damaged to prevent electrical hazards. Confirm fit.

Dishwasher repair set includes essential components for maintenance and fixes. Replace when parts show wear or damage. Verify fit with your model number.

This micro filter is a fine-mesh replacement filter that traps food particles and debris in the dishwasher sump, helping maintain wash performance and protect the pump and drain from clogs. What it does:

• Captures small food particles to prevent recirculation and reduce spotting
• Helps keep the dishwasher drain and pump from clogging
• Supports consistent water flow for better cleaning results
• Can reduce odors caused by trapped debris in the filter area

• Disconnect power and turn off water supply before servicing
• Remove the lower rack to access the sump area; follow your owner's manual for filter removal
• Ensure the filter is properly seated and locked before running a cycle
• Clean surrounding areas and inspect for additional debris while replacing the filter

This insulating part provides a non-conductive, heat-resistant barrier between adjacent components inside the appliance. Replacing a damaged insulator helps prevent unintended contact and heat transfer, supporting safe, reliable operation and protecting nearby parts. What it does:

• Electrically isolates terminals or metal surfaces to help prevent shorts or arcing
• Reduces heat transfer to surrounding components
• Maintains proper spacing and support for the protected component
• Replace if the original is cracked, deformed, missing, or shows burn/discoloration

• 1 insulating part

• Disconnect power before servicing; shut off gas or water if applicable
• Access the component, note orientation/positioning of the original insulator, and transfer any clips or hardware as required
• Seat the new insulator fully and ensure no conductive parts touch unintended surfaces
• Reassemble, restore power, and verify normal operation with no rubbing, arcing, or overheating