Bosch Dishwasher SHV09T13EU Parts

Drain hose clamp

Left hinge cap for dishwasher door assembly. Replaces cracked, broken, or missing hinge caps. Cosmetic and structural part for door hinge cover.

This decorative cover conceals the upper door hinge mechanism on the right side of dishwashers. Replace when the cover is cracked, discolored, or missing, affecting the appliance's appearance.

M6 x 26 screw secures the dishwasher door tension adjuster assembly. Replace if screw is stripped, missing, or loose to restore proper door alignment.

This dishwasher condensation hose adapter connects drainage tubing to remove moisture buildup from inside the dishwasher. It ensures proper water flow from the condensation system to prevent water accumulation in the unit. Replace this adapter if you notice water pooling in the bottom of your dishwasher, if there are leaks around the drainage area, or if the dishwasher isn't drying dishes properly.

Replacement frame for your dishwasher. This structural component provides support and mounting for internal parts. Order a new frame if yours is cracked or damaged.

Replace a cracked, broken, or missing dishwasher rack insert. This component installs into the dish rack to protect dishes and improve organization.

Upper rack crockery basket insert for dishwashers. Holds plates, bowls, and small dishware securely in the top rack. Replace if cracked or missing.

This drain pump assembly is responsible for expelling used water from the dishwasher tub during the drain cycle. It uses an impeller driven by a small motor to push water out through the drain hose. Replace this pump if the dishwasher fails to drain, leaves standing water at the bottom of the tub after a cycle, or if you hear the pump motor buzzing or humming without actually draining.

This is an optical sensor switch located in the rinse-aid dispenser of a dishwasher. It uses a light sensor to detect the level of rinse-aid remaining in the reservoir and signals the control board when a refill is needed. Replace this sensor if the rinse-aid indicator light stays on constantly, never illuminates, or if dishes come out with spots and streaks despite a full rinse-aid reservoir.

This rectifier converts alternating current (AC) to direct current (DC) to power electronic components within the dishwasher's control or motor circuit. It is a small electronic component typically mounted on or near the control board. Replace this rectifier if the dishwasher fails to start, experiences intermittent power issues, or if the control board is not receiving proper voltage.

Replacement screw that secures the fascia or control panel to the dishwasher cabinet. Needed when original fastener is stripped, missing, or damaged.

Inner door insulation that installs inside your dishwasher door. Replace if cracked, worn, or missing to restore thermal performance and heat retention.