Bosch Dishwasher SHV4803 UC/06 Parts

Drain hose clamp

This is the right hinge cap. For left hinge cap use 00165292.

This adjuster socket is the replacement socket used with a cabinet/appliance leveling foot to adjust and stabilize the unit. It lets you raise or lower the appliance for a level installation and steadier operation. What it does:

• Engages the appliance leveling foot so you can turn and set the height
• Restores proper leveling to reduce rocking, uneven doors, and drainage issues
• Provides a secure interface between the leg and adjustment tool or nut
• Durable replacement for worn or damaged socket components

• One adjuster socket

• Turn power off and unplug the appliance before accessing leveling components
• Access may require tipping or partially removing the front grill or toe panel per your model's service manual
• Verify correct socket orientation and thread engagement before lowering appliance back to floor

This plunger is a small push-style actuator that transfers motion between linked components, restoring proper mechanical engagement for the related mechanism. It's a direct-fit replacement designed to return a lever or latch to its resting position. What it does:

• Acts as the push/pull actuator in a latch, dispenser or control assembly to transmit motion
• Helps the related mechanism engage, release, or return smoothly when working correctly
• Common symptom: lever or latch fails to engage, stick, or does not return to home position
• Prevents intermittent operation caused by a worn or broken push rod

• One plunger

• Disconnect power before beginning any repair to avoid electrical or mechanical hazards
• Access may require removal of trim or housing panels; keep small parts organized
• Inspect mating pivot points and bushings for wear; replace if excessively worn

This M6 x 26 screw secures the dishwasher door tension/adjusting assembly so the door opens and closes smoothly. Replacement helps restore proper door alignment and reduces sagging, rattling, or uneven closing. What it does:

• Fastens the door tension/adjusting mechanism to the door assembly
• Maintains correct tension so the door stays level during use
• Helps stop door sag, uneven closing, or vibration noises related to a loose fastener

• Disconnect power and water supply before beginning any repair
• Use the correct M6 driver/socket and avoid stripping the head
• Thread the screw in straight and tighten until secure; do not overtighten

This inner door insulation replaces the insulating layer inside the appliance door to help maintain proper cooking or drying temperatures and reduce heat transfer to the outer door surface. It restores thermal performance and helps the door reach expected operating conditions. What it does:

• Replaces deteriorated or missing door insulation to reduce heat loss through the door
• Helps the appliance hold consistent internal temperatures for better cooking/drying results
• Can reduce outer door surface heat, lowering burn risk during normal operation
• Addresses issues like excessive door heat or long recovery times after opening the door

• One inner door insulation piece

• Disconnect power and allow the appliance to fully cool before starting work
• Installation typically requires removing the door outer panel; follow OEM instructions for your model
• Handle edges, clips, and panels carefully to avoid damage; use proper fasteners and orientation
• If adhesive or tape is present on the original part, replace with OEM-approved material when reassembling

This is the right side, side panel. For left side use 00213108.

This is the left side, side panel. For right side use 00213107.