Bosch Dishwasher SHX5AL02UC Parts

Secures panels, brackets, and trim pieces inside your dishwasher. Replace this fastener if stripped, missing, or damaged to restore tight assembly.

Creates a watertight barrier between dishwasher components. Replace if cracked, flattened, or leaking to prevent drips. Verify fit with your model.

Dishes coming out dirty or dishwasher not draining? This fine mesh filter traps food particles preventing clogs. Simple 5-minute DIY replacement.

This replacement screw secures appliance panels and internal brackets so components stay tight and aligned during everyday use. Replacing missing or stripped hardware restores a solid fit and helps minimize vibration and rattling.

• Fastens covers, panels, and brackets to their mounting points
• Helps maintain alignment of the attached component
• Reduces movement that can cause noise or wear
• Typical reasons to replace: missing screw, stripped head/threads, loose panel or bracket

• Disconnect power and, if applicable, shut off water before servicing
• Use the driver bit specified for your model; hand start threads to avoid cross-threading
• Tighten snugly without over-torquing to prevent stripping
• Replace screws one at a time to maintain alignment

This factory screw secures appliance components per the original design, helping stop looseness and vibration. Replace a missing, stripped, or corroded fastener to restore a solid, rattle-free fit and protect nearby parts from damage.

• Secures panels, brackets, or internal components as specified by the manufacturer
• Helps maintain proper alignment and reduces vibration or rattling
• Replace if the head is stripped, threads are damaged, or the screw is missing
• Common signs include loose or misaligned panels/trim and hardware that won't stay tight

• Disconnect power and turn off water or gas supply as applicable before servicing
• Match length and thread to the original; start by hand to avoid cross-threading
• Use the correct driver bit and tighten snugly without overtightening
• Retain any original washers, bushings, or clips used in the assembly

This is a support bracket that helps stabilize and align the dishwasher door or an internal component within the door assembly. It ensures the door opens, closes, and latches properly. Replace this bracket if the dishwasher door feels loose, sags when opened, does not align correctly with the latch, or if the original bracket is cracked or broken.

Replaces a cracked, scratched, or damaged dishwasher inner door panel. Protects internal components and restores the door interior appearance.

Factory mounting screw secures panels, brackets, and internal components in your dishwasher. Replace missing, stripped, or damaged screws during repair.

This is the dome-shaped cap that sits on top of the float assembly inside the dishwasher tub. It rises with the water level and triggers the float switch to shut off the water inlet valve when the proper fill level is reached, preventing overfilling. Replace this part if the dishwasher is overfilling with water, not filling at all, or if the dome is cracked, missing, or no longer moves freely.

Replacement dishwasher housing cabinet that restores the outer enclosure. Needed when the original is cracked, broken, or damaged, compromising stability.

Fix a dishwasher that won't complete cycles, stops mid-cycle, or shows error codes. This electronic control board restores proper operation and timing.

Replacement tension spring for dishwasher hinges and mechanisms. Restores proper tension when original spring is stretched, broken, or worn out.

Dishwasher door hinge provides pivot support for smooth opening and closing. Replace if door sags, won't stay open, or alignment is off. Confirm fit by model.

Secures internal components to the dishwasher cabinet. Replace if bracket is cracked, broken, or missing to restore stable mounting and alignment.

Replace cracked, broken, or missing dishwasher rack roller wheels. Snaps onto bottom or top rack to restore smooth gliding. Easy DIY installation.