Bosch Dishwasher SHX89PW75N Parts

Replacement lid cover for dishwasher internal components. Protects parts from debris and moisture. Direct replacement for cracked, broken, or missing lids.

Fix leaks from your dishwasher's pump sump area with this repair kit. Restores proper water flow and stops leaking without replacing the entire pump assembly.

Cable harness that connects electrical components in your dishwasher. Replace if wiring is frayed, damaged, or connections are loose or corroded.

Replacement dishwasher seal creates a watertight connection between components. Replace when leaks or pooling occur. Verify fit with your model number.

This micro filter is a fine-mesh replacement filter that traps food particles and debris in the dishwasher sump, helping maintain wash performance and protect the pump and drain from clogs. What it does:

• Captures small food particles to prevent recirculation and reduce spotting
• Helps keep the dishwasher drain and pump from clogging
• Supports consistent water flow for better cleaning results
• Can reduce odors caused by trapped debris in the filter area

• Disconnect power and turn off water supply before servicing
• Remove the lower rack to access the sump area; follow your owner's manual for filter removal
• Ensure the filter is properly seated and locked before running a cycle
• Clean surrounding areas and inspect for additional debris while replacing the filter

Fix dishwasher spray arm not rotating with this spindle shaft. Restores proper water distribution when the rotating shaft is worn or broken.

Replace your dishwasher's broken or cracked basket handle. This handle attaches to the upper or lower dish rack for easy loading and unloading access.

This is the base panel that attaches along the bottom front of the dishwasher, covering the underside components such as the motor and water connections. It helps protect internal parts from debris and provides a finished appearance. Replace this panel if it is cracked, warped, missing, or damaged from leaks or kicks.

This bearing clip secures a drum/tub bearing assembly to keep the bearing properly seated, helping maintain stable drum rotation and reduce wobble. Replace a worn or broken clip to restore correct bearing alignment. What it does:

• Holds the bearing in position so the drum/tub spins smoothly
• Prevents the bearing from shifting or slipping out of its mounting
• Can help reduce noise and wobble caused by a loose bearing
• Works as part of the bearing support system for the washer/drum assembly

• Recommended for installers or experienced DIYers; the correct service panels are removed before accessing the bearing area
• Disconnect power and water supply before beginning any repair
• Inspect adjacent bearings, seals, and mounting surfaces for wear and replace as needed
• Use proper tools to avoid damaging the clip or surrounding components during removal and installation