Bosch Dishwasher SMD53M06EP Parts

Trim strip finishes the exposed edge of your dishwasher where it installs. Replace if cracked, broken, or missing to restore a clean, finished look.

Does your dishwasher shake or make loud noises during the wash cycle? A worn suspension damper may be the cause. This part absorbs vibration and stabilizes the tub.

This float switch assembly detects the water level inside the dishwasher tub and signals the control board to stop filling when the correct level is reached. It acts as an overfill protection device to prevent water from flooding out of the machine. Replace this switch if the dishwasher overfills, does not fill with water at all, or triggers error codes related to water level sensing.

Replace your dishwasher's upper rack rail if cracked, broken, or worn. This guide rail installs along the sides to support smooth rack sliding.

Leaking water around the inlet valve? This rubber inlet seal creates a watertight connection at your dishwasher's water inlet to stop drips and leaks.

Secures your dishwasher to surrounding cabinetry for stable installation and proper door alignment. Replaces worn, missing, or broken brackets.

This base panel is the lower access kickplate that covers and protects the appliance's underside components while keeping a finished look at the front. It restores protection and appearance after damage or corrosion. What it does:

• Covers the appliance's lower front area to protect wiring, motors and other internal parts from debris
• Helps prevent drafts and keeps the cabinet base looking finished
• Common symptom: cracked, bent or missing lower panel exposing components
• Common symptom: rattling or scraping noises from loose or damaged kickplate
• Common symptom: cosmetic damage or rust on the lower front of the appliance

• One base panel

• Disconnect power (and water, if applicable) before beginning any work
• Typically installs from the front with a few screws or clips; small hand tools are usually required
• Handle edges carefully—metal panels can have sharp edges
• Secure all fasteners before returning the appliance to service

Replace your dishwasher door gasket when leaks appear or the seal feels hard and cracked. Restores watertight sealing. Confirm fit with your model number.

Fix corrosion or electrical issues caused by water damage. This moisture shield protects internal components from condensation. Simple DIY repair.

Replacement door spring for dishwashers. Installs on the door hinge assembly to assist with opening and closing. Needed when original is broken or worn.

Dishwasher cover component for protecting internal parts. Replaces cracked, broken, or missing covers. Essential for proper appliance assembly.

Door hinge for dishwashers. Secures and supports the door during opening and closing. Replace if cracked, broken, or worn to restore proper door function.