Bosch Refrigerator T36BB925SS Parts

Mounting screw for refrigerators and freezers. Secures internal components and panels. Replace if stripped, missing, or corroded during repairs.

This is the dishwasher sump filter housing that secures the filter assembly and helps trap food debris so wash water drains and circulates properly. Replaces a worn or cracked housing to restore proper filtration and flow. What it does:

• Houses the coarse/fine filter assembly and keeps filter components aligned
• Directs wash and drain water through the filter area to protect the pump
• Helps prevent large food particles from entering the pump and spray system
• Commonly used when filters are loose, cracked, or when debris is bypassing the filter

• Disconnect power and water supply before starting any repair
• Remove lower dishwasher rack and existing filter assembly to access the housing
• Inspect mating seals and gaskets; replace if brittle or damaged
• Reassemble filter components per OEM diagram and run a short cycle to check for leaks and proper drainage

This damper is the air-flow control assembly that regulates fresh air circulation in the appliance to help maintain consistent temperatures and compartment performance. Replaces a worn or stuck damper to restore proper airflow. What it does:

• Opens and closes to direct fresh air between compartments or from the outside vent
• Helps maintain even temperatures by regulating incoming air
• Commonly linked to symptoms like uneven cooling, warm spots, or reduced airflow
• Can fail by sticking, not opening fully, or making noise during operation

• One damper assembly

• Disconnect power to the appliance before starting any repair
• Handle the damper and actuator gently to avoid damaging plastic gears or mounting tabs
• Verify orientation and secure mounting; ensure linkage or actuator is properly engaged

Replacement rack guide rail for dishwasher racks. Installs along the side to enable smooth sliding. Replace if cracked, broken, or worn to restore proper alignment.

This is the outer door panel for a front-load washing machine. It forms the exterior-facing surface of the washer door, providing a finished appearance and structural support for the door assembly. Replace this panel if it is cracked, dented, or cosmetically damaged, or if the surface has deteriorated to the point where it no longer supports the door's components properly.