Bosch Washer WAS20360TR Parts

Replace your washer's program selector knob if it's cracked, broken, or missing. This control knob installs on the front panel to select wash cycles.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Suspension spring for washer drum support system. Attaches between tub and cabinet to absorb vibration. Replace if broken, stretched, or detached.

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

2 included - Front load

Replacement mounting bracket holder that secures internal components in your washer. Replaces worn, cracked, or broken holders to prevent rattling.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Washer tub seal prevents water leaks between the outer tub and transmission. Replace if you notice leaking during cycles. Verify fit with your model number.

This glass front panel replaces a cracked or damaged outer door surface to restore appearance and protect internal components. It provides the visible exterior surface for the appliance door and keeps the interior sealed from everyday wear. What it does:

• Replaces broken, cracked, or scratched outer door glass to restore the appliance's exterior
• Protects controls and internal layers behind the door from impact and debris
• Restores a smooth, easy-to-clean surface and original appearance
• Helps prevent sharp edges or glass fragments from exposing internal parts

• Handle carefully; wear cut-resistant gloves and eye protection to avoid injury from sharp edges
• Remove power to the appliance before starting any disassembly
• Follow OEM disassembly instructions for removing the door assembly and separating layers—do not force components
• If adhesive or clips are used, replace any damaged fasteners and allow adhesives to cure per manufacturer guidance

If detergent isn't dispensing properly or the cup is cracked, this washer dispenser tray restores proper detergent release during wash cycles.

Fix washer not filling or slow fill with this inlet hose. Stops leaks at connection points and restores proper water delivery. Direct-fit replacement.

This fixing kit supplies the mounting and fastening hardware used to secure appliance components during installation or repair, helping restore proper fit and reduce vibration or loose panels. Ideal for replacing missing or damaged fasteners. What it does

• Provides the specific screws, clips, and brackets used to anchor panels or assemblies
• Stops rattling and vibration caused by loose or missing mounting hardware
• Restores proper alignment of doors, panels, or internal components
• Replaces worn or corroded fasteners that can compromise a secure fit

• Disconnect power and water before beginning any repair work
• Use proper tools and follow the appliance manufacturer's installation instructions
• Inspect surrounding components and mounting surfaces; replace any damaged parts

Replacement rear tub assembly for your washer. This structural component houses the drum and bearings. Order a new one if your original is cracked or damaged.

13mm wrench designed for washer installation and maintenance. Used to remove shipping bolts and adjust leveling legs. Replace if lost or damaged.

This built-under kit allows a freestanding dishwasher to be installed underneath a countertop by replacing the standard top lid with a low-profile cover. It includes the necessary panel and hardware for a secure, flush fit beneath the counter surface. Use this kit when converting a freestanding unit to a built-in configuration or if the existing built-under panel is damaged.