Bosch Washer WAS244C0EE Parts

Replacement holder for washer detergent dispenser. Secures dispenser components in place. Order a new holder if original is cracked or broken.

Replacement drain hose for washers. Connects washer tub to household drain pipe. Replace if cracked, leaking, kinked, or damaged. Essential plumbing part.

Structural back panel for your washer. Replaces the rear cover if cracked, damaged, or missing. Restores proper enclosure and protects internal components.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Suspension spring for washer drum support system. Attaches between tub and cabinet to absorb vibration. Replace if broken, stretched, or detached.

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

2 included - Front load

Replacement mounting bracket holder that secures internal components in your washer. Replaces worn, cracked, or broken holders to prevent rattling.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Washer tub seal prevents water leaks between the outer tub and transmission. Replace if you notice leaking during cycles. Verify fit with your model number.

If detergent isn't dispensing properly or the cup is cracked, this washer dispenser tray restores proper detergent release during wash cycles.

Fix washer not filling or slow fill with this inlet hose. Stops leaks at connection points and restores proper water delivery. Direct-fit replacement.

Replacement rear tub assembly for your washer. This structural component houses the drum and bearings. Order a new one if your original is cracked or damaged.

This built-under kit allows a freestanding dishwasher to be installed underneath a countertop by replacing the standard top lid with a low-profile cover. It includes the necessary panel and hardware for a secure, flush fit beneath the counter surface. Use this kit when converting a freestanding unit to a built-in configuration or if the existing built-under panel is damaged.