Bosch Washer WAS24742CH Parts

Replace your washer's program selector knob if it's cracked, broken, or missing. This control knob installs on the front panel to select wash cycles.

Replacement holder for your washer's detergent dispenser. Installs in the dispenser drawer housing. Replace if cracked, broken, or missing.

Replacement holder for washer detergent dispenser. Secures dispenser components in place. Order a new holder if original is cracked or broken.

Replacement drain hose for washers. Connects washer tub to household drain pipe. Replace if cracked, leaking, kinked, or damaged. Essential plumbing part.

Structural back panel for your washer. Replaces the rear cover if cracked, damaged, or missing. Restores proper enclosure and protects internal components.

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Suspension spring for washer drum support system. Attaches between tub and cabinet to absorb vibration. Replace if broken, stretched, or detached.

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

2 included - Front load

Replacement mounting bracket holder that secures internal components in your washer. Replaces worn, cracked, or broken holders to prevent rattling.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Washer tub seal prevents water leaks between the outer tub and transmission. Replace if you notice leaking during cycles. Verify fit with your model number.

This glass front panel replaces a cracked or damaged outer door surface to restore appearance and protect internal components. It provides the visible exterior surface for the appliance door and keeps the interior sealed from everyday wear. What it does:

• Replaces broken, cracked, or scratched outer door glass to restore the appliance's exterior
• Protects controls and internal layers behind the door from impact and debris
• Restores a smooth, easy-to-clean surface and original appearance
• Helps prevent sharp edges or glass fragments from exposing internal parts

• Handle carefully; wear cut-resistant gloves and eye protection to avoid injury from sharp edges
• Remove power to the appliance before starting any disassembly
• Follow OEM disassembly instructions for removing the door assembly and separating layers—do not force components
• If adhesive or clips are used, replace any damaged fasteners and allow adhesives to cure per manufacturer guidance

If detergent isn't dispensing properly or the cup is cracked, this washer dispenser tray restores proper detergent release during wash cycles.

Replace your washer's door window frame if cracked, broken, or worn. This structural component secures the viewing window in the front load door assembly.