Bosch Washer WAS28464SN Parts

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Replacement mounting bracket holder that secures internal components in your washer. Replaces worn, cracked, or broken holders to prevent rattling.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Washer tub seal prevents water leaks between the outer tub and transmission. Replace if you notice leaking during cycles. Verify fit with your model number.

If detergent isn't dispensing properly or the cup is cracked, this washer dispenser tray restores proper detergent release during wash cycles.

Replace your washer's door window frame if cracked, broken, or worn. This structural component secures the viewing window in the front load door assembly.

This built-under kit allows a freestanding dishwasher to be installed underneath a countertop by replacing the standard top lid with a low-profile cover. It includes the necessary panel and hardware for a secure, flush fit beneath the counter surface. Use this kit when converting a freestanding unit to a built-in configuration or if the existing built-under panel is damaged.

Fix a washer that overfills or won't stop filling. This pressure chamber hose restores water-level sensing so your washer fills correctly every cycle.

Detergent dispenser insert for washers. Replaces cracked, broken, or missing inserts in the dispenser drawer. Direct fit replacement part.

Washer not filling properly or overfilling? The pressure chamber works with the water-level sensor to detect correct fill levels. Moderate DIY repair.

Single mounting screw for securing washer panels, brackets, and assemblies. Replace damaged, stripped, or missing screws to restore secure attachments.

Replacement drain hose for your washer. Connects the washer tub to the drain outlet. Replace if cracked, leaking, kinked, or showing signs of wear.

Secures hoses and components in your washer to prevent shifting and vibration. Replace if worn, bent, or missing for reliable operation. Confirm fit.