Bosch Washer WAW285H1UC Parts

Fix washer electrical issues with this cable harness. Solves power connection problems, display malfunctions, and control failures. Direct fit replacement.

If your washer won't start, stops mid-cycle, or shows error codes, the cable harness may have failed. This wiring connector restores power flow.

Fix washer control issues with this wire harness. Solves display errors, cycle problems, and electrical faults. Direct-fit installation takes 30-45 minutes.

This fixing kit supplies the mounting and fastening hardware used to secure appliance components during installation or repair, helping restore proper fit and reduce vibration or loose panels. Ideal for replacing missing or damaged fasteners. What it does

• Provides the specific screws, clips, and brackets used to anchor panels or assemblies
• Stops rattling and vibration caused by loose or missing mounting hardware
• Restores proper alignment of doors, panels, or internal components
• Replaces worn or corroded fasteners that can compromise a secure fit

• Disconnect power and water before beginning any repair work
• Use proper tools and follow the appliance manufacturer's installation instructions
• Inspect surrounding components and mounting surfaces; replace any damaged parts

Replace a cracked or warped lower dispenser tray that prevents proper detergent release. This plastic tray holds the detergent cup in your washer door.

This program power control module restores the electronic control that manages oven/dishwasher program selection and power distribution, allowing the appliance to respond to user inputs and run selected cycles. Fits units that use the listed part number. What it does:

• Replaces a failed electronic control that supplies power and program signals to the appliance
• Can stop unresponsive control panels, blank displays, or failure to start selected cycles
• Works as the main logic/power interface between user controls and appliance components

• One program power control module

• Disconnect power to the appliance before starting any service to avoid shock or damage
• Handle the board by the edges and avoid touching components; observe ESD precautions
• Some disassembly (control panel or console removal) and connector unplugging are required; keep fasteners and wire routing marked