Bosch Washer WFH206DEE Parts

Plastic bushing that sits between the washer door hinge and pivot point. Replace when worn, cracked, or causing loose door alignment and noisy operation.

Fix a washer that won't stop filling or overfills during cycles. This water level pressure switch senses and regulates fill levels to restore proper operation.

Secures rotating components in your washer to prevent movement and vibration. Replace if parts feel loose or noisy. Confirm fit with your model number.

Water pooling under your washer? A cracked or clogged drain reservoir housing disrupts wastewater flow. This repair restores proper drainage.

This shaft seal fits around the main drive shaft where it passes through the outer tub of the washing machine. It prevents water from leaking out of the tub and into the motor or bearing area. Replace this seal if you notice water dripping from beneath the tub, hear grinding noises during the spin cycle, or find water pooling under the machine.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

Coupling that connects the program knob to the timer mechanism on your washer. Replace if cracked, stripped, broken, or missing for proper cycle selection.

Replace a broken spin speed knob coupling if your washer control knob spins freely or won't change settings. Simple DIY repair in under 30 minutes.

Replace a worn, cracked, or loose spin speed selector dial on your washer. This control knob installs on the control panel to restore clear settings.

Fix fabric softener not dispensing properly with this washer dispenser insert. Direct replacement part installs in minutes with no special tools needed.

Fix detergent not dispensing or leaking in your washer. This dispenser drawer replacement restores proper soap flow. Moderate DIY repair in 20-30 minutes.

This fastening ring secures mating appliance components by locking parts in place to prevent movement or separation during operation. It's a simple yet essential hardware piece that helps maintain proper alignment and reliable function. What it does

• Holds mating parts together to prevent wobble, vibration, or dislocation
• Keeps seals and assemblies properly seated to reduce noise and misalignment
• Helps maintain correct component spacing for smooth operation
• Commonly replaced when the original ring is bent, worn, or missing

• Designed for use with compatible OEM assemblies; follow for correct placement
• Inspect mating surfaces and replace any damaged clips, seals, or gaskets before reassembly
• Use proper tools to avoid deforming the ring during installation; do not force into place
• Disconnect power and follow safety procedures before servicing the appliance

This dispenser tray is a removable insert that fits inside the detergent dispenser drawer of a washing machine. It separates compartments for detergent, bleach, and fabric softener so each is dispensed at the correct point in the wash cycle. Replace this tray if it is cracked, warped, or clogged with residue that cannot be cleaned, which can cause improper dispensing of laundry products.