Bosch Washer WFR2866GB Parts

This is a door hook or holder that latches the dryer door securely in the closed position during operation. It engages with the door strike or catch to keep the door from opening while the dryer is running. Replace this part if the dryer door won't stay closed, pops open during a cycle, or if the hook is visibly cracked or broken.

Water pooling under your washer? A cracked or clogged drain reservoir housing disrupts wastewater flow. This repair restores proper drainage.

Fix washer overfilling or underfilling issues with a water level pressure switch replacement. Controls water amount during wash cycles. Moderate DIY repair.

This shaft seal fits around the main drive shaft where it passes through the outer tub of the washing machine. It prevents water from leaking out of the tub and into the motor or bearing area. Replace this seal if you notice water dripping from beneath the tub, hear grinding noises during the spin cycle, or find water pooling under the machine.

This interference capacitor suppresses electrical noise and radio-frequency interference to help the appliance's electronics run more reliably. It fits on the control board and supports stable operation by filtering stray voltage spikes. What it does:

• Filters electrical and radio-frequency interference that can cause erratic control behavior or false error codes
• Reduces electrical noise that can affect nearby audio or radio reception
• Helps protect control circuitry from transient voltage spikes
• Commonly used when appliance exhibits intermittent faults or unexplained control glitches

• Disconnect power to the appliance before starting any repair
• Discharge capacitors and avoid touching leads; use insulated tools and follow safe-handling practices
• Replace only with the exact part specified for your model and secure all wire connections firmly

This is a water inlet fill hose that connects the household water supply to the washing machine. It carries fresh water into the washer during the fill cycle. Replace this hose if you notice leaking at the connections, cracks or bulging in the hose body, or if the washer is not filling with water properly.

Fix fabric softener not dispensing properly with this washer dispenser insert. Direct replacement part installs in minutes with no special tools needed.

Speed nut secures the fascia panel on your washer. Replace if the original nut is stripped, missing, or no longer holding the panel firmly in place.

Control knob for washer cycle selection panel. Replaces damaged, cracked, or missing knobs that prevent program settings from being adjusted properly.

Fix washer not draining or slow drainage with this drain pump tube. Connects pump to reservoir. Moderate DIY repair, typically 30-45 minutes.

Fix detergent not dispensing or leaking in your washer. This dispenser drawer replacement restores proper soap flow. Moderate DIY repair in 20-30 minutes.

Replace your washer's door window frame trim to restore sealed appearance and proper alignment. Fits cracked or damaged exterior trim. Verify model fit.

This fastening ring secures mating appliance components by locking parts in place to prevent movement or separation during operation. It's a simple yet essential hardware piece that helps maintain proper alignment and reliable function. What it does

• Holds mating parts together to prevent wobble, vibration, or dislocation
• Keeps seals and assemblies properly seated to reduce noise and misalignment
• Helps maintain correct component spacing for smooth operation
• Commonly replaced when the original ring is bent, worn, or missing

• Designed for use with compatible OEM assemblies; follow for correct placement
• Inspect mating surfaces and replace any damaged clips, seals, or gaskets before reassembly
• Use proper tools to avoid deforming the ring during installation; do not force into place
• Disconnect power and follow safety procedures before servicing the appliance