Bosch Dryer WTA3500GB Parts

A sealing kit designed to replace worn seals in the dishwasher pump area to stop leaks and restore a watertight pump assembly. Ideal when seals fail and allow water to escape around the pump. What it does:

• Replaces worn or damaged pump seals to help stop leaks beneath the machine
• Restores the pump assembly's watertight seal for proper water circulation and drainage
• Helps prevent water damage to the cabinet and flooring caused by seal failure
• Commonly used when you find water under the dishwasher, visible leaks near the pump, or damp cabinet flooring

• One sealing kit

• Disconnect power and shut off the water supply before starting any repair
• Access usually requires removing the lower access panel and may require partial pump disassembly
• Keep track of small seals and O-rings during removal; inspect related parts for wear

Dryer door seal creates an airtight barrier to retain heat and improve efficiency. Replace if torn, cracked, or causing heat loss. Verify fit with your model.

This genuine OEM replacement part is a pulley assembly for dryers. Sometimes called an idler arm, the pulley assembly keeps the dryer drive belt under tension as the belt wraps around the dryer drum. If the dryer is no longer spinning properly and is making a lot of noise, the pulley assembly may need to be replaced. Luckily this repair is a relatively simple process.To remove the old dryer pulley assembly, start by making sure the dryer is unplugged. Remove the lint screen from the top of the dryer. Remove the two Phillips screws by the lint screen opening. Depress the clips that hold the top cover down. Lift the top cover and keep it in an upright position. Disconnect the wire harness to the switch that separates the connector. Remove the screws on the front panel. Lift the panel forward and set it to the side. Next, lift the drum and locate the pulley assembly under the drum. Lift the belt off the motor pulley to remove the assembly. Set the new pulley assembly in the same position as the old one and make sure everything is aligned. Rotate the drum to make sure it rotates smoothly. reinstall the panels.This replacement part is sold individually and is compatible with Bosch, Gaggenau, and Thermador dryers.

Drum support plate for dryers. Mounts beneath the drum to provide structural support. Replace if cracked, warped, or causing alignment issues.

This OEM-grade silicone lubricant helps reduce friction and protect rubber seals, gaskets and moving plastic parts from wear. It keeps components moving smoothly and helps maintain appliance performance over time. What it does:

• Reduces friction on sliding parts, hinges and rollers to prevent sticking and squeaks
• Protects rubber seals and gaskets from drying, cracking and premature wear
• Helps preserve plastic and metal contact points exposed to moisture
• Safe for use on appliance components where silicone-based grease is recommended

• Apply a thin, even layer only to the intended contact surfaces; avoid excess that can attract debris
• Do not apply near electrical contacts, heating elements or motor windings
• Wear gloves and follow manufacturer safety guidance; keep out of reach of children

This flexible exhaust air hose routes hot, moist air from the appliance to the household vent, helping maintain proper ventilation and reduce moisture buildup. It's a direct-replacement vent hose used in the dryer/exhaust path. What it does:

• Provides a sealed pathway for hot air and moisture to exit the appliance
• Restores proper airflow when the original hose is damaged, crushed, or disconnected
• Helps prevent excess lint accumulation in the appliance cabinet and ductwork
• Can reduce long dry times and overheating caused by restricted exhaust

• One exhaust air hose

• Disconnect power (and gas, if applicable) and pull the appliance away from the wall before starting
• Secure hose with appropriate clamps or fasteners and ensure a smooth, unobstructed route
• Inspect surrounding components and vent path for lint or damage while replacing the hose

If your dryer door won't stay closed or the latch broke off, this door latch fixes the problem. Quick 15-minute DIY repair with a Torx screwdriver.