Bosch Dryer WTE86171EX Parts

This is a dishwasher drain pump assembly that removes standing water from the tub so cycles can finish and dishes can drain properly. Direct-fit replacement for affected drain systems. What it does:

• Pumps wastewater from the dishwasher to the household drain during drain cycles
• Restores normal draining when a failed pump leaves water in the tub
• May correct symptoms such as standing water, cycle failures, or unusual pump noise
• Works with the dishwasher's drain hose and check valve to prevent backflow

• Disconnect electrical power and water supply before starting any repair.
• Confirm compatibility using your appliance model number; inspect seals and hose connections during replacement.
• Handle the impeller and motor housing carefully; avoid crushing wiring or connectors.
• Run a short test cycle and check for leaks after installation.

This replacement sheet is a protective metal panel that helps shield internal components and restore proper fit where the original panel is damaged or missing. It's a direct-fit repair part used in appliance body and interior assemblies. What it does:

• Shields internal wiring and components from contact, debris, and minor impacts
• Helps maintain proper airflow paths and component spacing inside the appliance
• Can reduce rattles or vibration caused by a loose or damaged panel
• Restores a finished appearance when the original sheet is bent, corroded, or missing

• Disconnect power (and water if applicable) before starting any repair
• Handle edges carefully; sheet metal can be sharp—wear gloves and eye protection
• Removal/replacement typically requires basic hand tools; follow the appliance service manual for exact fastener locations

Dryer door hinge provides the pivot point for smooth opening and closing. Replace if hinge is cracked, broken, worn from repeated use, or missing.

This is the inner frame that fits inside the dryer door, providing structural support and holding the door components in place. It forms the interior-facing portion of the door assembly and helps maintain a proper seal during operation. Replace this frame if it is cracked, warped, or broken, which can cause the door to not close properly or allow heat to escape during drying cycles.

Fix a dryer making loud noises or not tumbling with a new drum. This part holds clothes during the drying cycle and may rust, dent, or crack over time.

Dryer door seal creates an airtight barrier to retain heat and improve efficiency. Replace if torn, cracked, or causing heat loss. Verify fit with your model.

This is the inner glass window panel that fits into the dryer door assembly. It allows you to see the drum and clothing during the drying cycle. Replace this part if the glass is cracked, shattered, or has become cloudy and difficult to see through.

Replacement rotary program selector knob for your dryer control panel. Restores reliable cycle selection when original is cracked, broken, or missing.

Replacement top lid cover for dryers. Protects internal components and restores finished appearance. Replaces cracked, broken, or missing lids.

Small spacer that maintains proper clearance between dryer components. Replace if cracked, missing, or worn to prevent parts from rubbing or misaligning.

Suspension spring for dryer drum support system. Installs between the drum and cabinet to absorb vibration. Replace if stretched, broken, or missing.

Sealing ring creates airtight barrier to prevent leaks in your dryer. Replace when worn or cracked to restore proper seal. Verify fit with your model.