Bosch Dryer WTE86300 Parts

Seals the gap between your dryer door and drum to contain heat and prevent lint escape. Replace if torn, cracked, or causing longer dry times.

Supports and seals your dryer door for proper alignment. Replace if door leaks air, won't close securely, or makes excessive noise. Verify fit with model.

Dryer cover restores a secure closure over openings, protecting internal components. Replace when cracked, broken, or missing to maintain fit and appearance.

Missing or damaged condensate drain hose? This dryer drain hose channels moisture from your condensation dryer to your household drain. Easy DIY fix.

This is a heat exchanger filter assembly used in condenser dryers. It helps recover heat from the exhaust air and condense moisture so the dryer can operate without an external vent. Replace this part if drying times have increased significantly, the dryer is overheating, or the unit is not properly removing moisture from clothes.

This is the inner frame that fits inside the dryer door, providing structural support and holding the door components in place. It forms the interior-facing portion of the door assembly and helps maintain a proper seal during operation. Replace this frame if it is cracked, warped, or broken, which can cause the door to not close properly or allow heat to escape during drying cycles.

Dryer drum baffle lifts and tumbles clothes while circulating air evenly. Replace if cracked, loose, or causing noise. Verify fit with your model number.

This is a blower wheel that mounts inside the dryer's blower housing and circulates heated air through the drum during the drying cycle. It is driven by the drive motor and pushes air through the lint filter and exhaust vent. Replace this part if your dryer takes too long to dry clothes, makes squealing or rattling noises from the blower area, or fails to circulate air properly.

Tension roller for dryers. Mounts to the support bracket to maintain proper belt tension around the drum. Replace if worn, squeaking, or damaged.

This is a replacement seal used to restore a watertight connection and help prevent leaks in compatible appliances. It provides a simple, low-cost way to replace a worn or damaged sealing element. What it does:

• Creates a secure, leak-resistant barrier at the mating surfaces where installed
• Helps stop visible leaks and drip symptoms associated with damaged seals
• Restores intended sealing performance when original gasket or seal is deteriorated

• Inspect mating surfaces for damage or debris and clean before installing the new seal
• Make sure the seal seats evenly and is fully inserted into its groove or recess
• Replace only with the correct OEM part number for a proper fit
• Disconnect power and water supply and follow appliance safety procedures before servicing

Dryer won't start or door won't stay closed? This door latch assembly secures the door during operation, allowing cycles to run. Moderate DIY repair.

Dryer won't start or drum won't turn? A faulty motor assembly is often the cause. This part powers both the drum and blower. Moderate difficulty repair.

Dryer won't heat or overheats? This thermal cutoff limiter cuts power to the heating element when temperature exceeds safe limits. Moderate DIY repair.

Replacement mounting bracket holder that secures internal components in place. Install when original is cracked, broken, or missing to restore proper alignment.

If your dryer won't turn on or has no power, the power cord may be damaged or disconnected. This cord supplies electricity to all dryer components.

Replacement drum taper cone for your dryer. This structural component secures the drum assembly. Order a new taper if yours is cracked or damaged.