Bosch Dryer WTL5100SN Parts

Replacement door hinge for dryers. Supports and aligns the door for smooth opening and closing. Order when your hinge is broken, cracked, or bent.

This mechanical door latch secures the dishwasher door during operation so cycles can run safely and the unit can seal properly. It replaces a worn or broken latch to restore reliable door closure and cycle starts. What it does:

• Physically holds and locks the door closed during wash cycles
• Triggers or maintains the door-closed state so the control will allow the cycle to start
• Commonly replaces units that are cracked, bent, or no longer latching
• Resolves symptoms like a door that won't stay closed, a dishwasher that won't start, or intermittent cycle interruptions

• Disconnect power to the appliance before beginning any repair
• Remove the inner door panel to access the latch; keep fasteners organized
• Inspect surrounding strike and mounting tabs for damage before installing

This genuine OEM replacement part is a pulley assembly for dryers. Sometimes called an idler arm, the pulley assembly keeps the dryer drive belt under tension as the belt wraps around the dryer drum. If the dryer is no longer spinning properly and is making a lot of noise, the pulley assembly may need to be replaced. Luckily this repair is a relatively simple process.To remove the old dryer pulley assembly, start by making sure the dryer is unplugged. Remove the lint screen from the top of the dryer. Remove the two Phillips screws by the lint screen opening. Depress the clips that hold the top cover down. Lift the top cover and keep it in an upright position. Disconnect the wire harness to the switch that separates the connector. Remove the screws on the front panel. Lift the panel forward and set it to the side. Next, lift the drum and locate the pulley assembly under the drum. Lift the belt off the motor pulley to remove the assembly. Set the new pulley assembly in the same position as the old one and make sure everything is aligned. Rotate the drum to make sure it rotates smoothly. reinstall the panels.This replacement part is sold individually and is compatible with Bosch, Gaggenau, and Thermador dryers.

This is a bearing used in the dryer drum support assembly. It allows the drum to rotate smoothly during operation by reducing friction between moving components. Replace this bearing if the dryer produces squealing, grinding, or rumbling noises during tumbling, or if the drum becomes difficult to turn by hand.

Drum support plate for dryers. Mounts beneath the drum to provide structural support. Replace if cracked, warped, or causing alignment issues.

Secures and supports your dryer's drive pulley for smooth belt and drum operation. Replace when worn to restore proper pulley alignment and reduce noise.

This OEM-grade silicone lubricant helps reduce friction and protect rubber seals, gaskets and moving plastic parts from wear. It keeps components moving smoothly and helps maintain appliance performance over time. What it does:

• Reduces friction on sliding parts, hinges and rollers to prevent sticking and squeaks
• Protects rubber seals and gaskets from drying, cracking and premature wear
• Helps preserve plastic and metal contact points exposed to moisture
• Safe for use on appliance components where silicone-based grease is recommended

• Apply a thin, even layer only to the intended contact surfaces; avoid excess that can attract debris
• Do not apply near electrical contacts, heating elements or motor windings
• Wear gloves and follow manufacturer safety guidance; keep out of reach of children