Bosch Dryer WTL5410 UC/10 (FD 8111-) Parts

This float detects water level inside the dishwasher tub and helps the control prevent overfill for reliable washing. Replaces the worn or stuck tub float to restore proper water-level sensing and reduce overflow risk. What it does:

• Rises and falls with tub water to engage the water-level sensing system
• Helps the control stop filling when the correct water level is reached
• Common symptom: dishwasher overfills, leaks at the base, or shows continuous fill/drain cycles
• Common symptom: dishwasher stops mid-cycle or fails to start a fill due to a stuck or damaged float

• One float

• Disconnect power (unplug or switch off breaker) and turn off water supply before beginning
• Access typically from the dishwasher tub base or by removing the lower kickplate; your model's service instructions
• Handle the float and surrounding components gently; avoid forcing plastic tabs or clips
• After replacement, run a short test cycle to ensure normal fill and that leaks are not present

Includes 2 fuses & 2 fuse holders (fuse holders are not available separately).

This cap ring is a small retaining ring that secures and helps seal a mating component inside the appliance, restoring proper fit and preventing movement or leaks. Use it when the original ring is cracked, warped, or missing. What it does:

• Holds a cover, cap, or seal in place to maintain correct alignment
• Helps prevent water or air leaks at the joint where it installs
• Stops related components from shifting, reducing noise and wear
• Common symptom: visible breakage, looseness, or parts that fall out during use

• One cap ring

• Disconnect power and turn off water before servicing
• Note the ring orientation and any adjacent seals before removal
• Inspect mating surfaces and seals; replace damaged seals or fasteners as needed
• Typically a snap-fit or press-fit part; use appropriate tools to avoid deforming the ring

This end cap for a pulley assembly secures and supports the appliance drive pulley so the belt and drum run smoothly. Replacing a worn end cap restores proper pulley alignment and reduces noise from the drive area. What it does

• Holds the pulley in proper position on the shaft to maintain belt alignment
• Helps prevent excess pulley wobble that can cause noise or rubbing
• Supports smooth rotation of the pulley to reduce belt wear and slipping
• Addresses symptoms such as squealing, grinding, or loose-feeling drive components

• Disconnect power (and gas if applicable) before starting any repair
• Inspect surrounding pulley, bearings, and belt for wear and replace if needed
• Use correct tools and follow OEM service instructions for safe removal and installation