Bosch Dryer WTL5410UC10 Parts

This is a bearing used in the dryer drum support assembly. It allows the drum to rotate smoothly during operation by reducing friction between moving components. Replace this bearing if the dryer produces squealing, grinding, or rumbling noises during tumbling, or if the drum becomes difficult to turn by hand.

This float detects water level inside the dishwasher tub and helps the control prevent overfill for reliable washing. Replaces the worn or stuck tub float to restore proper water-level sensing and reduce overflow risk. What it does:

• Rises and falls with tub water to engage the water-level sensing system
• Helps the control stop filling when the correct water level is reached
• Common symptom: dishwasher overfills, leaks at the base, or shows continuous fill/drain cycles
• Common symptom: dishwasher stops mid-cycle or fails to start a fill due to a stuck or damaged float

• One float

• Disconnect power (unplug or switch off breaker) and turn off water supply before beginning
• Access typically from the dishwasher tub base or by removing the lower kickplate; your model's service instructions
• Handle the float and surrounding components gently; avoid forcing plastic tabs or clips
• After replacement, run a short test cycle to ensure normal fill and that leaks are not present

Drum support plate for dryers. Mounts beneath the drum to provide structural support. Replace if cracked, warped, or causing alignment issues.

Secures and supports your dryer's drive pulley for smooth belt and drum operation. Replace when worn to restore proper pulley alignment and reduce noise.

This high-temperature 220V, 15-watt oven light bulb restores bright interior lighting so you can monitor cooking progress without opening the door. It's built for sustained heat and replaces a burned-out or flickering lamp.

• Illuminates the oven cavity during baking, broiling, and cleaning cycles
• High-temperature design for continuous heat exposure
• Common failure symptoms: no light when switched on, dim or intermittent illumination, blackened glass, or a broken filament

• Disconnect power at the breaker and allow the oven to cool completely
• Remove the light lens/cover; unthread and remove the old bulb
• Thread in the new bulb of the same voltage and wattage; do not overtighten
• Reinstall the cover, restore power, and test the light