Bosch Dryer WTV76100CN Parts

Dryer drum baffle lifts and tumbles clothes while circulating air evenly. Replace if cracked, loose, or causing noise. Verify fit with your model number.

This is a blower wheel that mounts inside the dryer's blower housing and circulates heated air through the drum during the drying cycle. It is driven by the drive motor and pushes air through the lint filter and exhaust vent. Replace this part if your dryer takes too long to dry clothes, makes squealing or rattling noises from the blower area, or fails to circulate air properly.

Tension roller for dryers. Mounts to the support bracket to maintain proper belt tension around the drum. Replace if worn, squeaking, or damaged.

Dryer not heating or taking too long to dry? This heating element assembly restores normal drying performance by heating air as clothes tumble.

This is a replacement seal used to restore a watertight connection and help prevent leaks in compatible appliances. It provides a simple, low-cost way to replace a worn or damaged sealing element. What it does:

• Creates a secure, leak-resistant barrier at the mating surfaces where installed
• Helps stop visible leaks and drip symptoms associated with damaged seals
• Restores intended sealing performance when original gasket or seal is deteriorated

• Inspect mating surfaces for damage or debris and clean before installing the new seal
• Make sure the seal seats evenly and is fully inserted into its groove or recess
• Replace only with the correct OEM part number for a proper fit
• Disconnect power and water supply and follow appliance safety procedures before servicing

Dryer won't start or door won't stay closed? This door latch assembly secures the door during operation, allowing cycles to run. Moderate DIY repair.

Dryer won't start or drum won't turn? A faulty motor assembly is often the cause. This part powers both the drum and blower. Moderate difficulty repair.

Dryer not starting or displaying error codes? This control module manages cycle operations and settings. Moderately difficult repair requiring proper diagnosis.

If your dryer won't turn on or has no power, the power cord may be damaged or disconnected. This cord supplies electricity to all dryer components.

Replacement drum taper cone for your dryer. This structural component secures the drum assembly. Order a new taper if yours is cracked or damaged.

Access panel cover that shields internal components from dust and moisture. Replaces cracked, broken, or missing exterior panels to restore finish.

This replacement seal restores a tight, leak-resistant connection between mating components inside your appliance. Replacing a worn seal helps stop drips at the joint and keeps the system operating reliably without nuisance leak faults.

• Forms a compressible barrier between parts to prevent leakage at a connection point
• Helps protect nearby components from moisture intrusion and corrosion
• Typical failure signs: moisture around a joint, puddling beneath the unit, or leak/overflow error messages
• Replace if the original is cracked, flattened, cut, brittle, or missing

• Disconnect power and shut off the water supply before servicing
• Access the connection, note the seal's orientation, and remove the old seal
• Clean mating surfaces; lightly moisten the new seal and seat it evenly without twisting or pinching
• Reassemble and test for leaks before reinstalling covers or panels

Fix dryer control issues or motor problems with this metal paper capacitor. Stabilizes voltage for reliable electrical operation. Direct-fit part.

Dryer not heating or shutting off mid-cycle? A faulty thermal cutoff stops the heating element when temperatures exceed safe limits. Simple fix.