Electrolux Range PCFE307CAFC Parts

Replacement screw secures panels, trim, and internal components in your appliance. Needed when original fastener is missing, stripped, or damaged.

Replace a cracked, broken, or missing oven door spacer that maintains proper alignment and gap between door components. Installs in door assembly.

Replacement mounting screw that secures panels, trim, and components in ranges and ovens. Needed when original screws are lost, stripped, or damaged.

Size: 6-20 x 0.312 inch.

Replace a cracked, broken, or missing outer housing cover on your range. This trim piece protects internal components and restores the finished look.

Secures range trim, panels, and components to prevent rattles and loosening. Replace when clips break or lose tension. Confirm fit with your model number.

Replaces a worn, broken, or missing storage drawer glide for smooth sliding operation. Installs on the drawer track to restore proper alignment and movement.

Replace a squealing, noisy, or non-functioning convection fan in your range. This assembly circulates hot air for even cooking. Accessible via rear panel.

Replacement mounting screw for ovens and ranges. Secures panels, brackets, trim, and internal components. Replace missing or stripped screws to restore fit.

This is a black metal side panel that attaches to the left exterior side of the range, providing a finished appearance and structural support. It helps enclose and protect the internal components of the oven cavity. Replace this panel if it is dented, rusted, scratched, or damaged from heat exposure.

This bake element is the oven's lower heating element that provides steady, even heat for baking and roasting. Replacing a worn or damaged element restores proper oven heating and consistent cooking results. What it does

• Heats the oven cavity during bake cycles to maintain set temperatures.
• Replaces a broken or burnt-out lower element causing no heat.
• Helps correct uneven baking or undercooked dishes when the element is failing.
• Works with the oven's control and thermostat to regulate bake temperature.

• One bake (lower) oven heating element — exact fit as shown.

• Disconnect power to the appliance before attempting any service; this part operates on live voltage.
• Access typically requires removing the oven racks and the back panel or cavity access screws.
• Inspect terminal connections and insulation; replace any damaged wiring or hardware.

This is a metal cover that fits over the convection fan assembly in the back wall of the oven cavity. It protects the fan and heating element while allowing hot air to circulate evenly during convection cooking. Replace this cover if it is warped, cracked, or corroded, which can cause uneven heating or rattling noises during convection baking.

Seals gaps at the rear of your range while maintaining proper ventilation. Replace if damaged, cracked, or allowing air leaks. Confirm fit with your model.

This potentiometer is the rotary control that adjusts a user-selected setting by varying electrical resistance for precise control. It restores responsive knob control so the appliance responds correctly to user input. What it does:

• Replaces a worn or faulty rotary control to restore smooth adjustment of temperature/speed or other user settings.
• Converts knob rotation into an electrical signal the control board reads.
• Commonly used when settings jump, respond intermittently, or the knob has no effect.
• Fits as the direct electrical control component—not the decorative knob.

• One potentiometer

• Disconnect power before servicing to avoid shock or damage.
• Access may require removing panels or the control console; handle wiring gently.
• Match the connector and shaft type before installation; secure mounting to avoid movement.

Support plate that mounts to the bottom of your range oven cavity. Replace if the original plate is cracked, warped, or damaged from heat exposure.