Gaggenau Range EEJ886404 Parts

Door won't lock or difficult to open during self-clean? This oven door latch assembly secures the door and reports lock status to the control board.

Washer won't start or door won't lock? This door latch bolt secures the door closed during cycles, allowing your front-load washer to operate safely.

This is a replacement 4.2 x 8 mm screw used to secure internal panels and components in compatible appliances. It restores proper fastening where the original screw is missing, stripped, or damaged. What it does

• Fastens small appliance panels, brackets, or trim pieces in place
• Restores secure attachment when the original screw is lost or worn
• Helps eliminate rattles or loose parts caused by missing fasteners
• Matches OEM fit and threading for reliable replacement

• Use the correct size screwdriver or driver bit to avoid stripping the head
• Tighten securely but avoid over-torquing to prevent damage to parts or threads
• Turn power off and disconnect the appliance before servicing electrical areas

Restore smooth, controlled door movement and a tight oven seal with this door hinge. Replacing a worn hinge helps the door close fully, prevents heat loss, and brings back the original opening tension on top or bottom compartments.

• Controls door swing and spring tension for smooth opening/closing
• Maintains alignment so the door gasket seals evenly
• Helps the door stay closed during cooking and hold at designed positions
• Common symptoms: door won't close fully, drops/sags, uneven gap, squeaks/binds, or heat escaping

• Disconnect power at the breaker and allow the oven to cool completely
• Remove the door; support it to safely relieve hinge spring tension
• Note hinge orientation and attachment points; transfer and secure the hinge using existing mounting locations
• After reassembly, verify latch engagement and even gasket contact; many ovens use two hinges—replace in pairs if both show wear

This oven temperature probe is the internal sensor that monitors cooking cavity temperature so the oven control can regulate heat for accurate cooking and bake results. It's a direct-replacement sensing probe for compatible Bosch ovens. What it does:

• Measures internal oven temperature and sends readings to the control board
• Allows the oven to maintain set temperatures for consistent cooking
• Common symptoms of a failing probe: inaccurate oven temps, oven not reaching set temperature, or temperature-related error codes
• Works with the oven's control system to help cycle heating elements or gas valve

• Disconnect power to the appliance before servicing to avoid shock hazard
• Handle the probe and its wiring gently; avoid sharp bends or pulling on connectors
• Verify connector orientation and secure connections to the control board per OEM diagram

Fix an oven door that won't stay closed or lock properly with this door latch bolt. Secures door during cooking and self-cleaning cycles. Easy repair.

This oven temperature limiter is a safety device that prevents your oven from overheating by cutting power when temperatures exceed safe limits. It automatically resets when temperatures return to normal operating range. Replace if your oven isn't heating, shuts off unexpectedly during cooking, or won't maintain proper temperatures.

Replacement washer for oven door hinges. Installs between hinge components to reduce friction and wear. Order if your original washer is worn or missing.

Snap ring secures and retains components in place on various appliances. Replace if ring is cracked, broken, or missing to restore proper assembly.

Light socket for your range. Installs in the oven cavity or cooktop area to hold the interior light bulb. Replace if cracked, damaged, or no longer secure.

This safety device monitors oven temperature and shuts off heating elements if temperatures exceed safe limits. Replace when oven overheats, fails to reach proper temperatures, or heating elements cycle on and off erratically.