Gaggenau Range EES848144 Parts

Door won't lock or difficult to open during self-clean? This oven door latch assembly secures the door and reports lock status to the control board.

This is a cutting disc used in range and oven assemblies. It serves as a component in the internal mechanism of the appliance. Replace this disc if it shows signs of wear, cracking, or damage that affects the operation of the associated assembly.

This is a replacement 4.2 x 8 mm screw used to secure internal panels and components in compatible appliances. It restores proper fastening where the original screw is missing, stripped, or damaged. What it does

• Fastens small appliance panels, brackets, or trim pieces in place
• Restores secure attachment when the original screw is lost or worn
• Helps eliminate rattles or loose parts caused by missing fasteners
• Matches OEM fit and threading for reliable replacement

• Use the correct size screwdriver or driver bit to avoid stripping the head
• Tighten securely but avoid over-torquing to prevent damage to parts or threads
• Turn power off and disconnect the appliance before servicing electrical areas

Restore smooth, controlled door movement and a tight oven seal with this door hinge. Replacing a worn hinge helps the door close fully, prevents heat loss, and brings back the original opening tension on top or bottom compartments.

• Controls door swing and spring tension for smooth opening/closing
• Maintains alignment so the door gasket seals evenly
• Helps the door stay closed during cooking and hold at designed positions
• Common symptoms: door won't close fully, drops/sags, uneven gap, squeaks/binds, or heat escaping

• Disconnect power at the breaker and allow the oven to cool completely
• Remove the door; support it to safely relieve hinge spring tension
• Note hinge orientation and attachment points; transfer and secure the hinge using existing mounting locations
• After reassembly, verify latch engagement and even gasket contact; many ovens use two hinges—replace in pairs if both show wear

This oven temperature probe is the internal sensor that monitors cooking cavity temperature so the oven control can regulate heat for accurate cooking and bake results. It's a direct-replacement sensing probe for compatible Bosch ovens. What it does:

• Measures internal oven temperature and sends readings to the control board
• Allows the oven to maintain set temperatures for consistent cooking
• Common symptoms of a failing probe: inaccurate oven temps, oven not reaching set temperature, or temperature-related error codes
• Works with the oven's control system to help cycle heating elements or gas valve

• Disconnect power to the appliance before servicing to avoid shock hazard
• Handle the probe and its wiring gently; avoid sharp bends or pulling on connectors
• Verify connector orientation and secure connections to the control board per OEM diagram

Fix an oven door that won't stay closed or lock properly with this door latch bolt. Secures door during cooking and self-cleaning cycles. Easy repair.

This is a rubber or silicone sealing grommet used to create an airtight seal around openings or connections within the microwave. It helps prevent moisture, heat, and air from escaping or entering where components pass through panels. Replace this part if you notice steam leaking from unusual spots, rattling noises near sealed areas, or visible cracking and deterioration of the original seal.

This oven temperature limiter is a safety device that prevents your oven from overheating by cutting power when temperatures exceed safe limits. It automatically resets when temperatures return to normal operating range. Replace if your oven isn't heating, shuts off unexpectedly during cooking, or won't maintain proper temperatures.

This insert or lining fits inside the oven door, serving as a protective overlay between the inner and outer door panels. It helps with insulation and provides a finished interior surface on the door. Replace this part if the door liner is warped, discolored, cracked, or if heat is escaping excessively from the oven door.

This metal bracket serves as a mounting or support component inside a range or oven. It helps secure internal parts or panels in their proper position. Replace this bracket if it is bent, broken, or missing, which can cause loose or misaligned components.