Gaggenau Dishwasher GI230160 Parts

Replacement adjuster socket for dishwasher leveling feet. Installs at cabinet base to raise or lower the unit for level installation. Replace if cracked or stripped.

Fix detergent door that won't open or latch properly. This dispenser plunger actuator restores mechanical engagement between the lid and release mechanism.

M6 x 26 screw secures the dishwasher door tension adjuster assembly. Replace if screw is stripped, missing, or loose to restore proper door alignment.

This dishwasher condensation hose adapter connects drainage tubing to remove moisture buildup from inside the dishwasher. It ensures proper water flow from the condensation system to prevent water accumulation in the unit. Replace this adapter if you notice water pooling in the bottom of your dishwasher, if there are leaks around the drainage area, or if the dishwasher isn't drying dishes properly.

Front corner block for dishwashers. Secures side panels at the top front of the unit. Replace if cracked, broken, or missing to restore proper fit.

Replacement cutlery basket for your dishwasher. Holds silverware and utensils during wash cycles. Order a new basket if yours is cracked or missing.

Leaking water around the inlet valve? This rubber inlet seal creates a watertight connection at your dishwasher's water inlet to stop drips and leaks.

Upper rack crockery basket insert for dishwashers. Holds plates, bowls, and small dishware securely in the top rack. Replace if cracked or missing.

Fix corrosion or electrical issues caused by water damage. This moisture shield protects internal components from condensation. Simple DIY repair.

This is an optical sensor switch located in the rinse-aid dispenser of a dishwasher. It uses a light sensor to detect the level of rinse-aid remaining in the reservoir and signals the control board when a refill is needed. Replace this sensor if the rinse-aid indicator light stays on constantly, never illuminates, or if dishes come out with spots and streaks despite a full rinse-aid reservoir.

This rectifier converts alternating current (AC) to direct current (DC) to power electronic components within the dishwasher's control or motor circuit. It is a small electronic component typically mounted on or near the control board. Replace this rectifier if the dishwasher fails to start, experiences intermittent power issues, or if the control board is not receiving proper voltage.

This is a trim strip used on the dishwasher to provide a finished edge or seal along a panel surface. It helps cover gaps and gives the appliance a clean, polished appearance. Replace this strip if it is cracked, broken, missing, or no longer staying in place, which can affect the look of the dishwasher or allow moisture to reach areas it shouldn't.

Leaking during wash cycles or poor drainage? This dishwasher water tube routes water between internal components. Repairs damaged tubes causing leaks.