Kenmore Refrigerator 106.32842010 (10632842010, 106 32842010) Parts

Size: 3/8 inch.

Size: 3/4 inch.

This is a replacement screw used to secure appliance panels and components. It restores proper fit and prevents loose parts that cause vibration, rattling, or misalignment for a tighter, safer assembly. What it does:

• Secures covers, trim, brackets, or control panels to the appliance frame
• Keeps components aligned to prevent rattling and movement during operation
• Replaces stripped, missing, or damaged fasteners that compromise fit
• Helps restore structural stability for normal operation

• Disconnect power and turn off water supply before beginning any repair
• Use the correct screwdriver or driver bit to avoid stripping the head
• Hand-start the screw and tighten until snug; avoid over-tightening which can crack plastic or strip threads
• If threads are damaged, replace with correct OEM fastener.

Size: 8-32 x .312 inch.

Size: 1/4 lb.

Size: 1/4 inch.

This wire harness connects the appliance's control and power circuits to internal components, restoring reliable electrical routing for controls, motors, and heating elements. Use when wiring is damaged, burned, or causing intermittent power issues. What it does:

• Routes power and signals between the control board and internal components for proper operation
• Replaces damaged, frayed, or burned wiring that can cause intermittent operation or failure to start
• Helps resolve symptoms such as no power to components, control errors, or appliances that run intermittently
• Restores secure plug-and-play connections to maintain safe, reliable electrical paths

• Disconnect power before starting; this part services live electrical circuits
• Inspect connectors and mating points; replace if terminals are corroded or damaged
• Route harness away from heat sources and moving parts; secure with existing clips or ties

This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does

• Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
• Helps isolate vibrating components from appliance chassis to lower perceived sound.
• Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
• Useful when worn, detached or hardened factory pads allow increased noise.

• One insul-sound deadening pad

• Disconnect power before servicing an appliance to avoid shock or injury.
• Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
• Replace only in the original location; do not cover vents or moving parts.
• If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.