Kenmore Ice Maker 106.4689482991 (1064689482991, 106 4689482991) Parts

Ice maker not producing ice or won't turn on? This switch controls power to your ice maker. Quick 15-minute fix to restore ice production in your unit.

Replacement fastener nut for securing panels, brackets, and components in various appliances. Needed when original nut is stripped, missing, or corroded.

White handle mounting screw for ice makers. Secures the door handle in place. Order a replacement if your original screw is stripped, lost, or damaged.

Foam insulation panel that fits inside refrigerator doors to maintain temperature efficiency. Replace if cracked, compressed, or missing.

Water pooling under your ice maker? A cracked or damaged drain tube causes leaks and floor damage. This 15-inch tube restores proper drainage flow.

Replacement top hinge for ice maker doors. Installs at the upper door corner. Order if your original hinge is broken, cracked, or no longer holds securely.

Bottom door hinge for freestanding ice makers. Mounts at the base of the door to provide pivot support. Replace if cracked, bent, or worn from use.

Size: 8-18 x 3/4 inch.

This scoop holder is a replacement freezer-door accessory that keeps the ice scoop secure, hygienic, and within easy reach. It restores the built-in storage location so your scoop stays put and ready when you need it. What it does:

• Provides a dedicated clip/mount to hold the ice scoop on the freezer door or bin
• Keeps the scoop off surfaces to reduce contamination and dripping
• Prevents the scoop from falling out when opening or closing the door/bin
• Restores proper storage when the original holder is cracked, broken, or missing

• Typically snaps into the designated slot on the freezer door or bin; no special tools required for most installs
• Align the holder and press firmly until it clicks into place; replace cracked or broken surrounding tabs if necessary
• Handle gently to avoid damaging door bins or trim during installation

Electrical shield for ice makers. Protects wiring and electrical components from moisture and debris. Replace if cracked, damaged, or missing.

Wiring channel for ice makers. Organizes and protects electrical wires inside the unit. Replace if cracked, broken, or missing to secure wiring properly.

Secures power cord to your ice maker or refrigerator. Replace if cracked, broken, or missing to prevent cord damage and ensure safe operation. Verify fit.

This fan mounting bracket secures the evaporator/condenser fan assembly so the fan stays aligned and runs quietly. It's a direct-fit replacement that restores proper airflow and reduces vibration from a loose or damaged bracket. What it does:

• Holds the refrigerator/freezer fan motor or blade in the correct position to maintain consistent airflow
• Prevents fan wobble and contact with surrounding components that cause noise or damage
• Helps restore cooling performance impacted by a detached or broken fan mount
• Works with the existing fan motor and blade when the bracket is the only damaged part

• One fan mounting bracket

• Basic hand tools required; access may require removing interior panels or the evaporator/condenser cover
• Power off and unplug the appliance before starting any repair to avoid shock or injury
• Keep screws and mounting hardware from the old bracket; replace only if damaged or missing
• If the fan motor or blade shows damage, inspect and replace those components as needed

White front grill panel for freestanding ice makers. Replace this cosmetic part if your original grill is cracked, discolored, or missing.