Kenmore Refrigerator 106.51153110 (10651153110, 106 51153110) Parts

Refrigerator roll pin secures moving parts and mechanical assemblies. Replace if pin is missing, damaged, or causing loose components in your unit.

This small black plastic cover caps the door stop area on the refrigerator, providing a finished appearance and protecting the underlying hardware. It snaps into place over the door stop or wire routing point on the cabinet. Replace it if the cover is cracked, broken, or missing, which can leave internal wiring or door stop components exposed.

Wire tie secures and organizes internal wiring harnesses in your appliance. Replace if the original tie is broken, cracked, or missing during repairs.

Replaces a cracked or damaged evaporator drip tray in your refrigerator. Installs beneath the evaporator coils to catch condensation and defrost water.

Replace your refrigerator's ice dispenser flipper door if cracked, broken, or missing. Installs in the dispenser chute to control ice flow.

Freezer storage bin for your refrigerator. Installs inside the freezer compartment. Replace if cracked, broken, or missing to restore organization.

Black refrigerator door handle for easy opening and closing. Replaces cracked, broken, or worn handles. Installs on the exterior door panel.

Replacement clip for refrigerators and freezers. Secures shelves, bins, or internal components. Order a new clip if yours is broken, cracked, or missing.

The Icemaker Assembly is an OEM part for Whirlpool refrigerators. It includes all the necessary components to replace or install an icemaker in your refrigerator, ensuring you can consistently produce and store ice efficiently

Symptoms of a failing Icemaker Assembly include:

• No ice production or very little ice being made
• Ice cubes that are smaller than normal or misshapen
• Leaking water in the freezer compartment
• Unusual noises during the ice making cycle, such as clicking or buzzing

Causes of a bad icemaker can include issues with the water inlet valve, freezer temperature not being cold enough, or mechanical failures within the icemaker itself, such as a faulty motor or an obstructed fill tube.

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This ice container (ice bin) stores ice made by the icemaker and interfaces with the dispenser drive to deliver cubes or crushed ice. Replacing a cracked or worn bin restores dependable ice storage and dispensing performance.

• Holds finished ice and guides it to the dispenser chute
• Engages the drive to move ice out when the dispenser is activated
• A cracked, warped, or stripped bin can cause no/slow ice dispensing or jams
• Damage may prevent the bin from seating fully or allow ice to spill/frost up

• Unplug the refrigerator or switch off power at the breaker before servicing
• Remove the old bin, clear any clumped ice, and seat the new bin so the rear drive interface engages—do not force
• Restore power and allow the icemaker to produce ice before testing dispensing

This is a rear panel cover that attaches to the back of the refrigerator, enclosing and protecting internal components. It helps maintain proper airflow and keeps dust and debris away from mechanical and electrical parts. Replace this cover if it is cracked, warped, or missing, which can lead to reduced cooling efficiency or excessive noise.

Replace worn refrigerator door hinge cam bushings to restore smooth door swing and proper alignment. Fixes doors that don't close fully or seal correctly.