Kenmore Refrigerator 106.51264101 (10651264101, 106 51264101) Parts

This replacement receiver lens covers and protects the appliance's infrared/receiver area and indicator light while allowing signals and status lights to show through clearly. It restores proper protection and visibility for the sensor/indicator assembly. What it does:

• Protects the IR/receiver and indicator area from dust, spills, and impact
• Allows remote/IR signals and indicator lights to pass through without obstruction
• Replaces cracked, discolored or missing lens that can hide status lights or reduce signal clarity
• Helps maintain original appearance of the control/console area

• Disconnect power to the appliance before beginning any repair.
• Remove the control console or front panel per the service manual to access the lens.
• Handle the lens gently to avoid scratching; seat it into the bezel until it snaps or rests securely.

This wire harness supplies electrical connections to the refrigerator ice maker assembly, restoring reliable power and signal routing so the ice maker can cycle and harvest ice properly. What it does

• Provides the factory electrical connections between the ice maker and the refrigerator controls.
• Replaces damaged or frayed wiring that can cause the ice maker to stop cycling or power up.
• Helps restore intermittent or no-power symptoms to the ice maker assembly.
• Maintains correct connector fit and routing to prevent shorts or loose connections.

• One wire harness for the ice maker assembly.

• Disconnect power to the appliance before servicing to avoid shock or injury.
• Match connectors and routing to the factory harness; secure with existing clips or fasteners.
• Inspect mating connectors and the ice maker for damage before reconnecting power.

This replacement ice door is the dispenser flap that opens and closes to release ice from the freezer into the dispenser chute, restoring normal ice delivery and helping keep the dispenser sealed when idle. What it does:

• Replaces a cracked, warped, or broken dispenser/ice door that won't open or close properly
• Helps stop ice from jamming or falling into the dispenser area
• Restores the seal that keeps warm air out of the ice chute
• Works with the dispenser actuator to allow normal ice dispensing

• Disconnect power to the refrigerator before starting any work.
• Remove the dispenser housing trim per your model's service instructions to access the door; handle carefully to avoid damaging surrounding components.
• Inspect the actuator arm and mounting tabs during install; replace or realign if worn or broken.
• Test dispenser operation after installation to ensure the door opens and closes smoothly.

This wire assembly is the appliance wiring harness that connects controls and components to deliver power and signals. It restores reliable electrical connections and replaces damaged or frayed wiring to help your appliance operate safely. What it does:

• Routes power and control signals between components and the control board or switch
• Replaces broken, frayed, or burned wires that can cause intermittent operation or no power
• Helps stop electrical arcing and poor connections that may lead to erratic behavior
• Restores secure plug-and-socket connections for a stable electrical path

• One wire assembly (harness) as shown

• Always disconnect the appliance from power (unplug or switch off breaker) before starting
• Note wire routing and connector orientation or take photos to ensure correct reinstallation
• Handle connectors by the plug bodies, not the wires, and avoid pinching or stretching leads
• If you see heat damage or melted insulation on mating components, inspect and replace those parts as needed

This trim piece secures and finishes the edge of a basket assembly, restoring fit and appearance. It helps keep items seated and reduces edge wear for a cleaner, more functional rack or basket. What it does:

• Replaces a cracked, chipped or missing basket trim to restore a proper edge and fit
• Helps prevent items from snagging or catching on a damaged basket edge
• Restores the original appearance of the basket assembly
• Fits where a molded trim/edge piece is required to hold the basket components together

• Disconnect power and remove any stored items before starting repairs
• Removal/replacement typically requires basic hand tools; handle plastic parts carefully to avoid damage
• Inspect surrounding clips or fasteners and replace if worn to ensure a secure fit