Kenmore Refrigerator 106.54783802 (10654783802, 106 54783802) Parts

Black plastic hinge cover cap for side-by-side refrigerators. Replaces cracked, broken, or missing hinge covers that expose internal hardware.

Replace your cracked, broken, or loose refrigerator door handle. This part restores a secure grip for safe door operation and matches the original design.

This replacement receiver lens covers and protects the appliance's infrared/receiver area and indicator light while allowing signals and status lights to show through clearly. It restores proper protection and visibility for the sensor/indicator assembly. What it does:

• Protects the IR/receiver and indicator area from dust, spills, and impact
• Allows remote/IR signals and indicator lights to pass through without obstruction
• Replaces cracked, discolored or missing lens that can hide status lights or reduce signal clarity
• Helps maintain original appearance of the control/console area

• Disconnect power to the appliance before beginning any repair.
• Remove the control console or front panel per the service manual to access the lens.
• Handle the lens gently to avoid scratching; seat it into the bezel until it snaps or rests securely.

This small metal mounting clip secures the thermal fuse in place to maintain proper thermal contact and stable wiring. It helps keep the fuse positioned so the appliance can monitor temperature reliably and operate safely. What it does:

• Secures the thermal fuse to the appliance housing or duct to prevent movement
• Keeps the fuse in correct contact with temperature-sensing surfaces
• Helps prevent intermittent heating or thermal-sensor misreads caused by a loose fuse
• Useful when replacing a damaged or missing fuse retainer during fuse service

• One thermal fuse mounting clip

• Disconnect power to the appliance before servicing to avoid shock or injury
• Remove access panels per your model's service instructions to reach the fuse location
• Install clip in the same orientation as the original; use pliers if needed to seat it firmly
• Inspect the thermal fuse and wiring while installing; replace any damaged components per OEM guidance

Color: Biscuit

Refrigerator shelf track that mounts inside the cabinet to guide and support sliding shelves. Replace if cracked, broken, or worn to restore smooth operation.

Flat washer installs between fasteners and surfaces in your refrigerator assembly. Replace when worn, missing, or damaged to restore proper spacing.

Color: White. Size: 1 qt. can. Acrylic appliance paint.

Refrigerator not cooling or making unusual noises? This compressor system tube connects critical sealed system components for proper refrigerant flow.

Shelf ladder support for refrigerators. Installs inside the fresh food compartment to hold shelves in place. Replace if cracked, broken, or missing.

Black plastic grille for refrigerators. Installs on the front panel. Replace if your original grille is cracked, broken, or missing for a clean look.

Fixes unresponsive controls, cycle issues, or display errors. This electronic control board restores your refrigerator's interface and timed functions.

Protective shield guard for side-by-side refrigerators. Installs to protect internal components. Replace if cracked, broken, or missing.

Replace your refrigerator's main cabinet housing enclosure. This structural part supports internal components and maintains alignment. Ideal for cracked or damaged housings.

This is a replacement mounting screw used to secure appliance panels and small components. It provides a correct-fit fastener to restore secure attachment and eliminate rattles or loose parts. What it does:

• Secures trim, panels, brackets, or small assemblies to prevent movement and vibration
• Restores proper alignment when a worn or missing screw causes loose parts or noise
• Works as a direct-replacement fastener where the OEM screw specification is required

• One replacement screw

• Use the correct driver bit to avoid stripping the head; do not overtighten
• Disconnect power and follow appliance safety guidelines when accessing internal components
• If the original mounting hole or threads are damaged, repair or replace the mounting hardware before reinstalling