Kenmore Refrigerator 106.57862801 (10657862801, 106 57862801) Parts

Ice maker not dispensing cubes properly? This stripper arm guides ice through the maker. Common fix when tabs break. Takes about 15 minutes to install.

Fix squeaking or grinding ice makers with appliance-grade grease. Lubricates moving parts in refrigerators and freezers. Simple DIY application.

Secures air duct to housing, maintaining proper airflow alignment. Replace if broken or loose to prevent air leaks. Confirm fit with your model.

This lever activates ice dispensing when pressed and is located inside the refrigerator door's dispenser opening. Replace it if ice doesn't dispense when pressed, the lever is stuck, broken, or fails to return to its normal position.

Excessive frost in your freezer? This evaporator cover gasket seals the cover to prevent frost buildup and maintain consistent cooling performance.

This is the main electronic control board for the refrigerator, responsible for managing compressor cycles, fan operation, defrost timing, and temperature regulation. It mounts inside the refrigerator's control housing and connects to various sensors and components throughout the unit. Replace this board if the refrigerator is not cooling properly, displays error codes, runs continuously, or fails to start.

6 - 19 x .250

Sealer for refrigerant line insulation.

This is a single OEM replacement screw used to secure panels and components on compatible appliances. It restores proper fit and prevents loose or vibrating parts for a safer, more reliable repair. What it does

• Secures panels, brackets, and small components in appliance assemblies
• Restores proper alignment and fit when original screw is missing or damaged
• Prevents rattling, vibration noise, and parts shifting during operation
• Works where the OEM specifies this exact screw size and thread

• One replacement screw

• Unplug the appliance or shut off power before servicing
• Use the matching driver and avoid over-tightening to prevent stripping threads
• Verify correct screw length and thread engagement for the mounting point
• If other fasteners appear worn or damaged, inspect and replace as needed

Ice not dispensing or partially ejecting? This refrigerator ice maker ejector arm pushes ice cubes from the mold into the bin. Quick DIY fix.

Size: 3/16 inch.

Size: 5/16 inch.

Size: 3/8 inch.

Size: 3/4 inch.

Replacement screw for securing components inside your refrigerator. Needed when original screws are stripped, lost, or corroded during repairs.