Kenmore Refrigerator 106.58969701 (10658969701, 106 58969701) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: 2324712
$164.53
- Compare At:
-
$194.15
- You Save:
-
$29.62
Genuine Whirlpool part
By: Whirlpool
Part Number: 4388358
Includes both right and left hand sides.
More
$20.95
- Compare At:
-
$24.93
- You Save:
-
$3.98
Genuine Whirlpool part
By: Whirlpool
Part Number: W11544659
$20.95
- Compare At:
-
$24.93
- You Save:
-
$3.98
Genuine Whirlpool part
By: Whirlpool
Part Number: W11553819
This insul-sound deadening pad reduces vibration and noise by dampening panels and components in laundry and kitchen appliances. It's a small adhesive-backed sound/isolation pad used where noise or rattles transfer through metal surfaces. What it does
- Dampens rattles and reduces structure-borne noise from panels, cabinets and housings.
- Helps isolate vibrating components from appliance chassis to lower perceived sound.
- Commonly applied behind control panels, cabinet walls or on motor mounts to cut vibration transmission.
- Useful when worn, detached or hardened factory pads allow increased noise.
What's included
- One insul-sound deadening pad
Install notes
- Disconnect power before servicing an appliance to avoid shock or injury.
- Clean and dry mounting surface; press pad firmly to ensure adhesive contact.
- Replace only in the original location; do not cover vents or moving parts.
- If adhesive is weak, use OEM-approved adhesive; avoid solvents that may damage finishes.
More
$20.95
- Compare At:
-
$24.72
- You Save:
-
$3.77
Genuine Whirlpool part
By: Whirlpool
Part Number: W11606038
$45.95
- Compare At:
-
$54.22
- You Save:
-
$8.27
Genuine Whirlpool part
By: Whirlpool
Part Number: W11751592
$13.16
- Compare At:
-
$13.30
- You Save:
-
$0.14
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2154473
$15.95
- Compare At:
-
$19.14
- You Save:
-
$3.19
Genuine Whirlpool part
By: Whirlpool
Part Number: W10683556
$12.51
- Compare At:
-
$14.89
- You Save:
-
$2.38
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10178772
The Crisper Pan is an OEM part for Whirlpool refrigerators. It provides a dedicated space for storing fruits and vegetables, helping to maintain their freshness by regulating humidity levels within the drawer. The pan measures approximately 16 3/8" Wide X 15" Deep X 8 1/4" High.
You should replace this crisper pan if it becomes cracked or damaged. Causes of a bad crisper pan can include impact from dropping or overloading, wear and tear from frequent use, or damage from cleaning with harsh chemicals.
Symptoms of a bad crisper pan include:
- Cracks or holes in the pan
- Difficulty sliding the pan in and out of the refrigerator
- Food items not staying fresh as long
This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.
Do-It-Yourself Stories from Customers like You
Broken drawer Jeffrey U. • Lee Center , NY • February 24, 2015
My daughter forgot to close the drawer before closing the door and wammo!!! Easy fix, but hard on the wallet..AppliancePartsPros.com had it the cheapest.
Read more
More
$104.62
- Compare At:
-
$124.50
- You Save:
-
$19.88
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: W10271509
The Ice Auger Motor is an OEM part for Whirlpool refrigerators. This motor drives the ice auger, which moves ice from the ice bin to the dispenser chute.
Causes of a bad ice auger motor can include electrical malfunctions, wear and tear from regular use, or damage due to ice jams or overloading.
Symptoms of a bad ice auger motor include:
- The ice dispenser not dispensing ice
- Unusual noises or grinding sounds from the ice dispenser area
- The auger not turning or moving ice
- Intermittent or inconsistent ice dispensing
This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.
Do-It-Yourself Stories from Customers like You
Ice dispenser wasn't working Debra W. • Branson , MO • December 12, 2014
Watched video on replacing motor, ordered part, replaced it in less than 15 minutes. Works great!
Read more
More
$141.95
- Compare At:
-
$168.92
- You Save:
-
$26.97
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2181911
This hinge shim installs at the bottom refrigerator door hinge to fine-tune door height and alignment. Replacing a missing or damaged shim helps the door close smoothly and seal evenly for reliable performance.
- Positions the door by spacing the bottom hinge for correct height and alignment
- Helps restore smooth closing and consistent gasket contact
- Useful after hinge or gasket service to set the door-to-cabinet gap
What's included: 1 hinge shim Install notes:
- Disconnect power before servicing
- Support the door; remove bottom hinge fasteners and lift the door off per your manual
- Add or replace shim(s) on the bottom hinge, then reinstall and tighten hardware
- Check level and uniform gasket contact around the door
More
$24.76
- Compare At:
-
$26.12
- You Save:
-
$1.36
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: W10278732
Do-It-Yourself Stories from Customers like You
The ice maker would not shut off making ice even when the bin was full Kevin M. • Citrus Heights , CA • November 17, 2017
Spoke with a representive that diagnosed the problem as a bad control board. After receiving the new control board, I was able to easily perform the replacement by watching the step-by-step instructional video on the website. It is now functioning normally.
Read more
More
$47.95
- Compare At:
-
$56.58
- You Save:
-
$8.63
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: W10278731
Do-It-Yourself Stories from Customers like You
Crush ice maker blade bent Melton R. • Hampton , VA • December 27, 2014
I removed the shaft from ice bucket removed the blade below and pulled off bent blade. Put new blade in the bent blade spot put lower blade back on screwed it back into Ice bucket replaced in fridge and now it works perfectly without hanging up.
Read more
More
$47.95
- Compare At:
-
$57.06
- You Save:
-
$9.11
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2162358
This terminal block cover protects the appliance's electrical connection area from accidental contact and debris, helping reduce the risk of shorts and corrosion while keeping wiring secure and contained. What it does:
- Covers and shields the power terminal/block where the power cord connects
- Helps prevent accidental contact with live terminals and reduces short risk
- Keeps out dust, lint and debris that can cause corrosion or arcing
- Useful when the original cover is cracked, missing or showing burn marks
What's included: One terminal block cover (single piece) Install notes:
- Always disconnect power (unplug or switch off breaker) before servicing electrical components
- Typically installs over the terminal block and secures with the existing fastener(s); inspect mounting hardware for wear
- Replace if cracked, melted or if terminals are exposed; ensure cover seats fully before restoring power
More
$47.95
- Compare At:
-
$56.58
- You Save:
-
$8.63
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2203408W
$14.95
- Compare At:
-
$17.94
- You Save:
-
$2.99
Out Of Stock
Usually ships within 4 - 14 days
Genuine Whirlpool part
By: Whirlpool
Part Number: 8533917
This replacement screw secures panels, trim pieces and small assemblies so covers and components stay aligned and rattle-free. It's a simple, direct fastening part used when an original screw is missing or damaged. What it does:
- Fastens panels, trim, control housings and other small components to the appliance chassis
- Replaces missing, worn or stripped screws that cause loose panels or rattling noises
- Restores correct alignment of covers and trims after service or disassembly
- Provides a direct, hardware-level repair instead of temporary fixes
What's included: Screw Install notes:
- Disconnect power (and gas, where applicable) and ensure the appliance is cool before starting.
- Use the correct screwdriver bit and turn until snug; do not overtighten to avoid stripping threads or damaging parts.
- Keep removed hardware for reference; replace like-for-like if threads or inserts are damaged.
- Wear eye protection and gloves when working on appliances.
Do-It-Yourself Stories from Customers like You
Broken ice maker Dennis S. • Sevierville , TN • August 14, 2018
Replaced Ice maker and sensors ….
Read more
More
$10.38
- Compare At:
-
$11.74
- You Save:
-
$1.36
Out Of Stock
Usually ships within 4 - 14 days