Kenmore Refrigerator 106.9542981 (1069542981, 106 9542981) Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: WP1119018
This bearing nut secures a bearing and related rotating components on the shaft, keeping the assembly tight and aligned for smooth, dependable operation. Replacing a worn or stripped nut helps stop wobble, noise, and drive slippage.
- Locks the bearing/stack onto the shaft to prevent loosening
- Maintains alignment for smooth rotation and reduced vibration
- Helps restore consistent drive in shaft-driven assemblies
- Typical symptoms: loose or non-turning drive, rattling/grinding, or visible thread damage
What's included: 1 bearing nut Install notes:
- Disconnect power before servicing; shut off water if working near dispenser components
- Remove the related assembly to access the shaft; note part order for reassembly
- Hand-start the nut to avoid cross-threading; verify thread direction against the original
- Tighten securely; inspect the bearing, washers/spacers, and shaft for wear
Do-It-Yourself Stories from Customers like You
The bearing nut on the ice maker auger wore out letting the auger drop down causing it to hang up on ice cubes Morgan H. • Childersburg , AL • June 11, 2015
Replaced bearing nut with new one,took about 30 minutes.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2187464
Ice maker not producing ice or working intermittently? This wiring harness restores electrical connections to power ice production. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
No ice from the ice maker Jerome L. • Chicago , IL • March 24, 2021
Took it apart, replaced the cable. Now I have ice.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP1120581
This is the small motor assembly that opens and closes the ice chute door on the refrigerator's dispenser. It activates when the dispenser lever is pressed, allowing ice to pass through, and closes afterward to keep cold air from escaping. Replace this part if the ice chute door does not open when dispensing, stays stuck open allowing cold air to leak out, or makes grinding noises during operation.
Do-It-Yourself Stories from Customers like You
Water tube assembly. William R. • Tyler , TX • August 02, 2023
Used the parts ordered from AppliancePartsPros.com, along with Youtube video from AppliancePartsPros.com to replace the water tube assembly. Suggestions made in that video made the difference in making the repair or not making the repair.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP489128
Genuine Whirlpool part
By: Whirlpool
Part Number: 285006
Color: Black. Size: 12 oz. Acrylic appliance aerosol can spray paint.
Do-It-Yourself Stories from Customers like You
My 1984 dishwasher that still works great was an eyesore & I didn't match my other appliances. Dorothy L. • Raleigh , NC • March 24, 2014
I purchased a can of black appliance spray paint, removed the panels on the dishwasher, sprayed them, and a few hours later put them back. They're beautiful and it looks like I have a brand new dishwasher! It now matches everything and looks great with the new granite counter tops I just installed. THANK YOU FOR THE GREAT IDEA!!! I'm a 76 year old female and my friends think I'm a genius!
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 350956
Almond. Size: 13 oz. can. Acrylic appliance paint.
Do-It-Yourself Stories from Customers like You
Age no money to fix it Ronald V. • Cape Coral , FL • August 01, 2015
Was able to match it pretty well the natural age difference was good. The delivery of the product was amazing it took less than 24 hours to get to me and that was standard shipping. Give you guys an A for great !!
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W10309990
Fix a refrigerator that won't cool or runs constantly with this compressor. Essential sealed system component. Professional installation recommended.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W10278733
Ice crusher not working or producing inconsistent crushed ice? This rotating crusher blade restores proper ice crushing when worn, bent, or cracked.
Do-It-Yourself Stories from Customers like You
The ice maker would not shut off making ice even when the bin was full Kevin M. • Citrus Heights , CA • November 17, 2017
Spoke with a representive that diagnosed the problem as a bad control board. After receiving the new control board, I was able to easily perform the replacement by watching the step-by-step instructional video on the website. It is now functioning normally.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP1114631
Secures interior shelves and rails to the refrigerator cabinet. Replace if broken, missing, or loose to restore proper support and prevent tilting shelves.
Do-It-Yourself Stories from Customers like You
Broken track stud shelf shelf frame and cover John K. • Hyde Park , NY • December 10, 2015
The broken track and shelf stud were the most important part of the repair. I was astounded to find parts for a 20 year old fridge. I was concerned about how to remove the damaged stud. As luck would have it, your site contained a video on how to remove it. Without the video, I would not have been so successful and would most likely have done more harm than good. All I needed for the repair was an open end wrench. It took about 30 seconds to remove and replace. I could not be more please...
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP488878
Secures water supply hoses to fittings, preventing leaks in ice makers and refrigerators. Replace when rusted, bent, or losing grip. Verify fit.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP72107
Touch-up paint for appliances in almond color. Repairs chips, scratches, and worn spots on ovens, refrigerators, microwaves, and dryers.
Do-It-Yourself Stories from Customers like You
Broken meat drawer Jesse B. • Stow , MA • January 26, 2015
Replaced. Shippping was very fast. A good experience.
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: W10843121
Drier tube for refrigerators. Installs in the sealed refrigeration system to remove moisture. Replace if cracked, corroded, or during compressor repairs.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2161324
Fix frost buildup in your refrigerator with this defrost heater mounting clip. Secures heater to evaporator for consistent defrosting performance.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: 511873
White porcelain touch-up paint for repairing chipped, scratched, or worn surfaces on ranges, ovens, and refrigerators. Restores appearance on exterior panels and trim. 2 oz. can.
Do-It-Yourself Stories from Customers like You
Paint had chipped from refrigerator Earl D. • Port Neches , TX • September 23, 2016
Simply painted over worked great
Read more
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP1119005
Positions and supports the refrigerator step or kickplate. Replace this spacer if worn, missing, or broken to restore secure alignment and fit.
More
Genuine Whirlpool part
By: Whirlpool
Part Number: WP2155789
This fan scroll gasket seals the evaporator/fan housing to prevent air bypass and maintain proper airflow through the evaporator. Replacing a worn gasket helps restore efficient cooling and reduces frost buildup. What it does:
- Seals the fan scroll/evaporator housing to direct cold air through the evaporator fins
- Prevents air leaks that can cause reduced cooling or temperature fluctuations
- Helps reduce frost or ice buildup by ensuring consistent airflow over the coil
- Can reduce abnormal fan noise caused by air turbulence around a damaged seal
What's included: One fan scroll gasket. Install notes:
- Disconnect power to the appliance before beginning any work.
- Remove the evaporator/fan housing cover and carefully pull out the old gasket.
- Clean mating surfaces of debris and residue for a flush seal before installing the new gasket.
- Seat the gasket fully around the scroll; reassemble panels and restore power to test operation.
Do-It-Yourself Stories from Customers like You
Evaporator motor worked but was making the metal cover vibrate so loud that i distracted from converations and even the tv also the ice dispenser switch was intermittent Randall C. • Fort Worth , TX • July 06, 2026
Replaced Evaporator motor after watching the video. The new motor had the connectors on back side, but was still easy to hook up.
Also replaced the Dispenser Control bracket after watching the video.
Both jobs were very easy. So Quiet, I had to open the freezer to hear if the fan was running. Awesome!!
Read more
More