Kenmore Washer 110.47781701 (11047781701, 110 47781701) Parts

This should be plastered all over the place and every owner of a front end washer should be advised or a recall should be issued about this. As I opened the top of my washer to fix a F35 error by replacing the water level switch, which worked out great and it fixed the issue, I noticed a rusting spot at the bottom of the washer just under where the motor is placed. After running the washer with the lid open (I don't recommend doing that) I noticed that it was coming from the top of the soap... Read more

Very simple, just screwed them in, leveled, then tighten bolt. You need a second person to tilt the washer back. Read more

Ordered parts and replaced Read more

I first replaced the drive motor which was no longer wanting to spin or rinse clothes. It was completely dead in my 10 year old washer. Once I replaced, it would run, but give the F06 code. I then replaced the CPU and runs like a new machine. Very easy repairs made in less than an hour by a stay at home mom with little ones wanting to help. If I can do it, anyone can do it. Great videos on this website help you to know what you will be doing prior to making the repair. Highly recommend... Read more

I researched online what the errors meant and I found a couple of solutions. First, I tried all of the no-cost solutions and none of them worked. Then I tried replacing the water level switch. Easy project but it did NOT work, $100 down the drain. The next solution was replacing the Electronic Control Board ($350) and that worked. I unplugged the machine, removed the old control board - labeling the plug-ins to make the new install easier, plugged in the new board, and in less than 10... Read more

New inner drum and front and rear outer drum; although other parts worked, still replaced the bellow and clamp, new door latch, and cleaned the hoses. Washer works great. Just like brand new. Even though matching dryer works, I am going to clean it up and replace some parts on it also. Read more